PART
|
COLOR
|
LOCATION
|
DIAGRAM
|
12 VOLT CONSTANT
|
BROWN (+) and LIGHT GREEN (+)
|
@ IGNITION SWITCH HARNESS
|
|
STARTER
|
RED/LIGHT BLUE (+)
|
@ IGNITION SWITCH HARNESS
|
|
STARTER 2
|
N/A
|
|
|
IGNITION 1
|
WHITE/YELLOW (+)
|
@ IGNITION SWITCH HARNESS
|
|
IGNITION 2
|
PINK/BLACK (+)
|
@ IGNITION SWITCH HARNESS
|
|
IGNITION 3
|
N/A
|
|
|
ACCESSORY/HEATER BLOWER 1
|
GRAY/YELLOW (+)
|
@ @IGNITION SWITCH HARNESS
|
|
ACCESSORY/HEATER BLOWER 2
|
BLACK/GREEN (+)
|
@ IGNITION SWITCH HARNESS
|
|
KEYSENSE
|
N/A
|
|
|
PARKING LIGHTS ( - )
|
WHITE/BLACK (-)
|
@ LCM, GRAY 16-Pin Plug, Pin 13, See NOTE #3
|
|
PARKING LIGHTS ( + )
|
BROWN (+)
|
@ LCM, BLACK Plug, Pin 4, See NOTE #3
|
|
POWER LOCK
|
PINK/YELLOW (TYPE C), See NOTE #2
|
IN DRIVERS DOOR HARNESS
|
|
POWER UNLOCK
|
PINK/LIGHT GREEN (TYPE C), See NOTE #2
|
IN DRIVERS DOOR HARNESS
|
|
LOCK MOTOR WIRE
|
PINK/BLACK (5-WIRE TYPE)
|
IN DRIVERS DOOR HARNESS
|
|
DOOR TRIGGER
|
DARK BLUE (-) and BLACK/ORANGE (-) Use both, See NOTE #5
|
@ LCM, See NOTE #3
|
|
DOMELIGHT SUPERVISION
|
DARK BLUE (-), (Requires Part #775 Relay)
|
@ LCM, See NOTE #3
|
11701_Crown-Victoria_(-) NEGATIVE DOOR PIN ISOLATION CIRCUIT.pdf
|
TRUNK RELEASE
|
PURPLE/YELLOW (5-Wire), See NOTE #4, (Requires Part #775 Relay)
|
IN DRIVERS DOOR HARNESS
|
NewFiles_CROWN-VICTORIA_15317_CROWN-VICTORIA_FORD TRUNK RELEASE DIAGRAM.pdf
|
SLIDING POWER DOOR
|
N/A
|
|
|
HORN
|
DARK BLUE (-)
|
@ STEERING COLUMN HARNESS
|
|
TACH
|
Any wire that is NOT RED or RED/LIGHT GREEN (AC)
|
@ IGNITION COIL or FUEL INJECTOR
|
|
WAIT TO START LIGHT
|
|
|
|
BRAKE
|
LIGHT GREEN (+)
|
@ SWITCH ABOVE BRAKE PEDAL
|
|
FACTORY ALARM DISARM
|
N/A
|
|
|
ANTI-THEFT
|
FORD'S TRANSPONDER ANTI-THEFT SYSTEM, See NOTE #1
|
@ IGNITION SWITCH TUMBLER
|
|
NOTES
|
NOTE #1: Some of these vehicles use a Special Anti-theft key to remote start you will need a
Bypass module 791,(use this module IF you have a extra ignition key to place inside
the 791 to operate, if you do not have an extra key to use or wish not to have a key
placed inside this bypass module, we OFFER a KEYLESS INTERFACE BYPASS MODULE
that does not require a key to be placed inside the bypass modlue, this is Part #
PKALL or P KFM, either one will work, to order, go to the INTERFACE BYPASS MODULE
PAGE on this website.
NOTE #2; If vehicle is equipped with a FACTORY KEYLESS ENTRY System, then the vehicle has
a TYPE B Door Locking System, vehicles without FACTORY KEYLESS ENTRY, have a
TYPE C Door Locking System. Vehicles with the KEY PAD on the Door is considered to
have KEYLESS ENTRY.
NOTE #3: The LCM (Lighting Control Module) is located to the RIGHT of the STEERING COLUMN,
with its harness accessable between the steering column and the LCM.
NOTE #4: This vehicle uses a 5-Wire TRUNK RELEASE SYSTEM, and will require an extra relay
part #775, to connect, See DIAGRAM.
NOTE #5: this vehicle has 2 DOOR TRIGGER wires, when connecting to an ALARM SYSTEM,
use both DOOR TRIGGER wires and DIODE ISOLATE, to connect, See DIAGRAM.
|