PRINT
MERCURY SABLE
MODEL YEAR(S
SABLE 2004-2006
KEY T-HARNESS IMMOBILIZER
FDKEY-6 N/A FORD'S SECURILOCK ANTI-THEFT TRANSPONDER SYSTEM, Requires 791 and Extra Ignition Key, See NOTE #4
PART COLOR LOCATION DIAGRAM
12 VOLT CONSTANT LIGHT GREEN/PURPLE (+) @ IGNITION SWITCH HARNESS
STARTER RED/LIGHT BLUE (+) @ IGNITION SWITCH HARNESS
STARTER 2 N/A
IGNITION 1 RED/LIGHT GREEN (+) @ IGNITION SWITCH HARNESS
IGNITION 2 BLACK/LIGHT GREEN (+) @ IGNITION SWITCH HARNESS
IGNITION 3 N/A
ACCESSORY/HEATER BLOWER 1 GREY/YELLOW (+) @ IGNITION SWITCH HARNESS
ACCESSORY/HEATER BLOWER 2 N/A
KEYSENSE N/A
PARKING LIGHTS ( - ) N/A
PARKING LIGHTS ( + ) BROWN (+) @ SMJ, BOTTOM plug, Pin 31, See NOTE *1
POWER LOCK PINK/YELLOW (TYPE B) @ GEM, 26 Pin Plug, Pin 18, See NOTE *2
POWER UNLOCK PINK/LIGHT GREEN (TYPE B) @ GEM, 26 Pin Plug, Pin 6, See NOTE *2
LOCK MOTOR WIRE PINK/BLACK (+) @ SJB, TOP Plug, Pin 3, See NOTE *1
DOOR TRIGGER See NOTE *3 @ GEM, 26-Pin Plug, See DIAGRAM 14301_SABLE_(-) NEGATIVE DOOR PIN ISOLATION CIRCUIT.pdf
DOMELIGHT SUPERVISION BLACK/LIGHT BLUE (+) @ SJB, TOP Plug, Pin 22, See NOTE *1
TRUNK RELEASE PURPLE/YELLOW (+) @ GEM, 26 Pin Plug, Pin 3, See NOTE *2
SLIDING POWER DOOR N/A
HORN DARK BLUE (-) @ SJB, BOTTOM Plug, Pin 1, See NOTE *1
TACH Any wire that is NOT RED @ IGNITION COIL or FUEL INJECTOR
WAIT TO START LIGHT N/A
BRAKE RED/LIGHT GREEN (+) @ SWITCH ABOVE BRAKE PEDAL
FACTORY ALARM DISARM PINK/WHITE (-) @ GEM, 26 Pin PLug, PIN 4, See NOTE *2
ANTI-THEFT FORD'S SECURILOCK ANTI-THEFT TRANSPONDER SYSTEM @ IGNITION SWITCH TUMBLER
NOTES
NOTE *1 the SJB (Smart Junction Block) is part of the FUSE/RELAY box to the LEFT of the Steering Column, it has (3) three plugs to the LEFT of the fuses.





NOTE *2 the GEM (Generic Electronic Control) Module is part of the SJB (See NOTE *1)





NOTE *3 the DRIVERS DOOR is a YELLOW/BLACK(-) Pin 5, the PASSENGER DOOR is a GRAY/RED(-) Pin 19, the DRIVERS REAR DOOR is a LIGHT GREEN/YELLOW(-) Pin 20 and the PASSENGER REAR DOOR is a PINK/LIGHT BLUE(-) Pin 7. When connecting to an ALARM SYSTEM, use all 4 Door Trigger wires and DIODE ISOLATE, to connect, See DIAGRAM







NOTE #4: This vehicle is equipped with a Special Anti-theft key, to remote start you will

need a Bypass module 791, use this module IF you have a extra ignition key to

place inside the 791 to remote start, if you do not have an extra key to use or wish

not to have a key placed inside this bypass module, we OFFER a KEYLESS INTERFACE

BYPASS MODULE that does not require a key to be placed inside the bypass module,

this is Part # PKALL or PKFM, either one will work, to order, go to the INTERFACE

BYPASS MODULE PAGE on this website.
LINK 1 LINK TEXT 1 LINK 2 LINK TEXT 2