PRINT
CHRYSLER PACIFICA
MODEL YEAR(S
PACIFICA 2008
KEY T-HARNESS IMMOBILIZER
CHRKEY-4 N/A CHRYSLER'S TRANSPONDER ANTI-THEFT SYSTEM, See NOTE #1
PART COLOR LOCATION DIAGRAM
12 VOLT CONSTANT PURPLE/RED (+) @ BCM, (Plug(C1) Pin 1 , Note #2
STARTER YELLOW (+) @ IGNITION SWITCH, (BLACK 5-Pin Plug) Pin 4
STARTER 2 PURPLE/BROWN (-) thru a 180 Ohm Resistor, See NOTE #1 @ IGNITION SWITCH, (BLACK 5-Pin Plug) Pin 2
IGNITION 1 PINK/GRAY (+) @ IGNITION SWITCH, (BLACK 5-Pin Plug) Pin 3
IGNITION 2 N/A
IGNITION 3 N/A
ACCESSORY/HEATER BLOWER 1 Use STARTER 2, (-) thru a 560 Ohm Resistor, See NOTE #1
ACCESSORY/HEATER BLOWER 2 N/A
KEYSENSE N/A
PARKING LIGHTS ( - ) BROWN/WHITE (-) THRU A 920 Ohm Resistor @ HEADLIGHT Switch or BCM, (Plug(C5) Pin 31, Note #2
PARKING LIGHTS ( + ) N/A
POWER LOCK PURPLE/LT. BLUE (-) thru a 1.8K Ohm Resistor, Note #3 @ DDM, (BLACK, 20-Pin Plug) Pin 13, Note #4
POWER UNLOCK Use LOCK wire, (-) thru a 750 Ohm Resistor, Double Pulse, See Note #3
LOCK MOTOR WIRE N/A
DOOR TRIGGER PURPLE (-) @ DDM, (BLACK, 20-Pin Plug) Pin 11, Note #4
DOMELIGHT SUPERVISION YELLOW/WHITE (+) (Front) and YELLOW/ORANGE (+) (Dome Light) @ DRIVERS A Pillar or BCM, Plug(C2) Pins 6 and 7, Note #2
TRUNK RELEASE TAN/DK. GREEN (-) thrua 4.7K Ohm Resistor, Note #5 @ BCM, (Plug(C2) Pin 30, Note #2
SLIDING POWER DOOR N/A
HORN DK. GREEN/PURPLE (-) @ HORN Switch
TACH Any wire NOT BROWN/GRAY (3.8L) or PINK/BROWN (4.0L) (AC) @ Any FUEL INJECTOR
WAIT TO START LIGHT N/A
BRAKE WHITE/DK. GREEN (+) @ BRAKE Switch
FACTORY ALARM DISARM See Note #3
ANTI-THEFT CHRYSLER'S TRANSPONDER ANTI-THEFT SYSTEM, See NOTE #1 @ IGNITION SWITCH TUMBLER
NOTES
Note #1: CHRYSLERS TRANSPONDER SYSTEM, Requires Bypass Module, Part # DB-ALL or XK09

with NO RESISTORS OR RELAYS REQUIRED for REMOTE STARTING and KEYLESS

ENTRY, to order go to the INTERFACE BYPASS MODULE Page on this website.





Note #2: the BCM, (Body control Module) is located under the Drivers side of the Dash,

on the Firewall.





Note #3: the LOCK/UNLOCK wire is the Factory Alarm ARM/DISARM wire. On Base Models

this wire is not present. You will need to add this wire to the pin location. The wire

next to this open pin (13 on Base Models) is a ORANGE/TAN, Pin 12 and

LT. BLUE/WHITE, Pin 13.





Note #4: the DDM (Drivers Door Module) is part of the Power Window Switch in the Door.







Note #5: TEST this wire while opening the Liftgate from the Handle on the Rear of the Vehicle.

Vehicles with Power Liftgate, use a PURPLE/TAN(-) thru a 4.7K Ohm Resistor

@ BCM, Plug(C2) Pin 29.
LINK 1 LINK TEXT 1 LINK 2 LINK TEXT 2