PART
|
COLOR
|
LOCATION
|
DIAGRAM
|
12 VOLT CONSTANT
|
RED (+) and LIGHT GREEN/PURPLE (+)
|
@ IGNITION SWITCH HARNESS
|
|
STARTER
|
GREEN (+)
|
@ IGNITION SWITCH HARNESS
|
|
STARTER 2
|
N/A
|
|
|
IGNITION 1
|
WHITE/YELLOW (+)
|
@ IGNITION SWITCH HARNESS
|
|
IGNITION 2
|
N/A
|
|
|
IGNITION 3
|
N/A
|
|
|
ACCESSORY/HEATER BLOWER 1
|
YELLOW (+)
|
@ IGNITION SWITCH HARNESS
|
|
ACCESSORY/HEATER BLOWER 2
|
BLACK/GREEN (+)
|
@ IGNITION SWITCH HARNESS
|
|
KEYSENSE
|
N/A
|
|
|
PARKING LIGHTS ( - )
|
N/A
|
|
|
PARKING LIGHTS ( + )
|
See NOTE #2
|
See DIAGRAM
|
17044_WINDSTAR_FREESTAR WINDSTAR PARKING LIGHT DIAGRAM.pdf
|
POWER LOCK
|
LIGHT BLUE/ORANGE (TYPE B)
|
@ FEM, 20 Pin PLug, See NOTE #3
|
|
POWER UNLOCK
|
LIGHT GREEN/YELLOW (TYPE B)
|
@ FEM, 20 Pin Plug, See NOTE #3
|
|
LOCK MOTOR WIRE
|
RED/ORANGE (+)
|
@ FEM, 26-Pin Plug, See NOTE #3
|
|
DOOR TRIGGER
|
BROWN/PINK (-), See NOTE #4
|
IN PASSENGERS D PILLAR, See DIAGRAM
|
17044_WINDSTAR_WINDSTAR DOOR PIN ISOLATION CIRCUIT.pdf
|
DOMELIGHT SUPERVISION
|
USE DOOR TRIGGER, (Requires Part #775 Relay)
|
|
|
TRUNK RELEASE
|
N/A
|
|
|
SLIDING POWER DOOR
|
WHITE/LIGHT GREEN (-) (Left) and GREEN/RED (-) (Right) See NOTE #6
|
@ OVERHEAD CONSOLE SWITCHES
|
|
HORN
|
ORANGE/RED (-)
|
@ FEM, 12 Pin Plug, See NOTE #3
|
|
TACH
|
See NOTE #5
|
|
|
WAIT TO START LIGHT
|
N/A
|
|
|
BRAKE
|
RED/LIGHT GREEN (+)
|
@ SWITCH ABOVE BRAKE PEDAL
|
|
FACTORY ALARM DISARM
|
LIGHT BLUE/BLACK (-)
|
@ FEM, 26 Pin Plug, See NOTE #3
|
|
ANTI-THEFT
|
FORD'S ANTI-THEFT TRANSPONDER SYSTEM, SEE NOTE #1
|
@ IGNITION SWITCH TUMBLER
|
|
NOTES
|
NOTE #1: This vehicle is equipped with a Special Anti-theft key, to remote start you will
need a Bypass module 791, use this module IF you have a extra ignition key to
place inside the 791 to remote start, if you do not have an extra key to use or wish
not to have a key placed inside this bypass module, we OFFER a KEYLESS INTERFACE
BYPASS MODULE that does not require a key to be placed inside the bypass module,
this is Part # PKALL or PKFM, either one will work, to order, go to the INTERFACE
BYPASS MODULE PAGE on this website.
NOTE #2: This vehicle requires a Special Parking Light Daigram and 2 extra Relays part #775,
to connect, See DIAGRAM
NOTE #3; The FEM (Front Electronic Module) is located under the Drivers side of the dash
on the firewall.
NOTE #4: The BROWN/PINK wire must have a 1 AMP DIODE installed to prevent false alarms,
when connecting to an ALARM SYSTEM, to connect, See DIAGRAM
NOTE #5: The COIL PACK is located on the DRIVERS SIDE of the ENGINE, for TCH use the
PINK/WHITE, RED/LIGHT BLUE or BLUE/LIGHT GREEN
NOTE #6: the Sliding Doors on this vehicle are a (-)Negative type and there is a wire for each
door, to connect will require a Relay part # 775 for each door.
|