PRINT
TOYOTA LAND CRUISER
MODEL YEAR(S
LAND CRUISER 2008-2015
KEY T-HARNESS IMMOBILIZER
N/A N/A TOYOTA'S PROXIMITY (Smart Key) ANTI-THEFT SYSTEM, See NOTE #1
PART COLOR LOCATION DIAGRAM
12 VOLT CONSTANT BLACK (+) @ DRIVERS DASH FUSE BOX, (WHITE, 1-Pin Plug(A) Pin 1
STARTER NOT USED FOR REMOTE STARTING!
STARTER 2 N/A
IGNITION 1 NOT USED FOR REMOTE STARTING!
IGNITION 2 N/A
IGNITION 3 N/A
ACCESSORY/HEATER BLOWER 1 NOT USED FOR REMOTE STARTING!
ACCESSORY/HEATER BLOWER 2 N/A
KEYSENSE N/A
PARKING LIGHTS ( - ) PURPLE (-) @ HEADLIGHT SWITCH or BECU, (WHITE, 26-Pin Plug) Pin 23, NOTE #6
PARKING LIGHTS ( + ) GREEN (+) @ DRIVERS DASH FUSE BOX, (WHITE, 24-Pin Plug(C) Pin 22
POWER LOCK RED (TYPE B), (TEST with Passenger Switch), NOTE #2 @ DRIVERS DASH FUSE BOX, (WHITE, 66-Pin Plug(D) Pin 49
POWER UNLOCK GREEN (TYPE B), (TEST with Passenger Switch), NOTE #3 @ DRIVERS DASH FUSE BOX, (WHITE, 66-Pin Plug(D) Pin 52
LOCK MOTOR WIRE BLUE (5-wire type) @ DRIVERS DASH FUSE BOX, (WHITE, 24-Pin Plug(C) Pin 24
DOOR TRIGGER BLUE (-) @ BECU, (WHITE, 26-Pin Plug) Pin 24, NOTE #6
DOMELIGHT SUPERVISION GREEN (-) @ DRIVERS DASH FUSE BOX, (WHITE, 66-Pin Plug(D) Pin 51
TRUNK RELEASE BLUE (-) NOTE #4 @ BECU, (WHITE, 26-Pin Plug) Pin 26, NOTE #6
SLIDING POWER DOOR N/A
HORN GRAY to RED/WHITE (-) @ HORN SWITCH or DRIVERS DASH FUSE BOX, (WHITE, 24-Pin Plug(B) Pin 1
TACH WHITE (AC) @ BECU, (WHITE, 16-Pin Plug) Pin 8, NOTE #6
WAIT TO START LIGHT N/A
BRAKE RED (+) @ BRAKE SWITCH or DRIVERS DASH FUSE BOX, (WHITE, 24-Pin Plug(B) Pin 22
FACTORY ALARM DISARM YELLOW (-) @ BECU, (WHITE, 26-Pin Plug) Pin 10, NOTE #6
ANTI-THEFT TOYOTA'S PROXIMITY (Smart Key) ANTI-THEFT SYSTEM
NOTES
NOTE #1: This vehicle has TOYOTA'S PROXIMITY (Smart Key) ANTI-THEFT SYSTEM that Requires

a Special INTERFACE BYPASS MODULE Part # DBALL2 to REMOTE START,

TO ORDER CALL 800 561 1110 EX. 2146.





NOTE #2: this wire is only needed if the Door Locks do not function with the Aftermarket System

while the vehicle is running. All other times just use the Factory Alarm Arm wire.





NOTE #3: this wire is only needed if the Door Locks do not function with the Aftermarket System

while the vehicle is running. All other times just use the Factory Alarm Disarm wire.





NOTE #4: TEST this wire while opening the Liftgate from the Handle on the Rear of the

Vehicle.





NOTE #5: TEST this wire while turning the Key in the Drivers Door, this wire will also Unlock

the Doors.





NOTE #6: the BECU is located under the Driver Dash, attached to the Fuse Box.





LINK 1 LINK TEXT 1 LINK 2 LINK TEXT 2