|
PART
|
COLOR
|
LOCATION
|
DIAGRAM
|
|
12 VOLT CONSTANT
|
YELLOW (+) and LIGHT GREEN/PURPLE (+)
|
@ IGNITION SWITCH HARNESS
|
|
|
STARTER
|
RED/LIGHT BLUE (+)
|
@ IGNITION SWITCH HARNESS
|
|
|
STARTER 2
|
N/A
|
|
|
|
IGNITION 1
|
DARK BLUE/LIGHT GREEN (+)
|
@ IGNITION SWITCH HARNESS
|
|
|
IGNITION 2
|
RED/BLACK (+)
|
@ IGNITION SWITCH HARNESS
|
|
|
IGNITION 3
|
N/A
|
|
|
|
ACCESSORY/HEATER BLOWER 1
|
GREY/YELLOW (+)
|
@ IGNITION SWITCH HARNESS
|
|
|
ACCESSORY/HEATER BLOWER 2
|
BLACK/LIGHT GREEN (+)
|
@ IGNITION SWITCH HARNESS
|
|
|
KEYSENSE
|
N/A
|
|
|
|
PARKING LIGHTS ( - )
|
N/A
|
|
|
|
PARKING LIGHTS ( + )
|
BROWN (+)
|
@ HEADLIGHT SWITCH, See NOTE #2
|
|
|
POWER LOCK
|
PINK/YELLOW (TYPE C), See NOTE #3
|
IN PASSENGER KICK PANEL
|
|
|
POWER UNLOCK
|
PINK/LIGHT GREEN (TYPE C), See NOTE #3
|
IN PASSENGER KICK PANEL
|
|
|
LOCK MOTOR WIRE
|
N/A
|
|
|
|
DOOR TRIGGER
|
BLACK/YELLOW (-) and BLACK/PINK (-) Use both, See NOTE #4
|
IN EACH KICK PANEL at the DOOR HARNESS See DIAGRAM
|
10585_F-SERIES-LIGHT-DUTY_FORD DOOR PIN ISOLATION.pdf
|
|
DOMELIGHT SUPERVISION
|
BLACK/LIGHT BLUE (+)
|
IN PASSNEGER KICK PANEL
|
|
|
TRUNK RELEASE
|
N/A
|
|
|
|
SLIDING POWER DOOR
|
N/A
|
|
|
|
HORN
|
DARK BLUE (-)
|
@ STEERING COLUMN HARNESS
|
|
|
TACH
|
WHITE/PINK (AC)
|
@ PCM, See NOTE #5
|
|
|
WAIT TO START LIGHT
|
N/A
|
|
|
|
BRAKE
|
LIGHT GREEN (+)
|
@ SWITCH ABOVE BRAKE PEDAL
|
|
|
FACTORY ALARM DISARM
|
DARK GREEN/PURPLE (-)
|
IN DRIVERS KICK PANEL
|
|
|
ANTI-THEFT
|
FORDS TRANSPONDER ANTI-THEFT SYSTEM, See NOTE #1
|
TRANSPONDER @ IGNITION SWITCH TUMBLER
|
|
|
NOTES
|
NOTE #1: This vehicle is equipped with a Special Anti-theft key, to remote start you will need a
Bypass module 791,(use this module IF you have a extra ignition key to place inside
the 791 to remote start, if you do not have an extra key to use or wish not to have a
key placed inside this bypass module, we OFFER a KEYLESS INTERFACE BYPASS
MODULE that does not require a key to be placed inside the bypass modlue, this is
Part # PKALL or PKFM, either one will work, to order, go to the INTERFACE BYPASS
MODULE PAGE on this website.
NOTE #2; the (+) PARKING LIGHT wire may also be found at the TRAILER CONNECTOR next
to the Diagnostic Connector under the dash.
NOTE #3: If vehicle is equipped with FACTORY KEYLESS ENTRY it is a TYPE "B" Door Locking
System, without FACTORY KEYLESS it is a TYPE "C". Use the DRIVERS SIDE Switch
as the Master Switch when testing.
NOTE #4: This vehicle has 2 door triggers, when connecting to an ALARM SYSTEM, use both
wires and DIODE ISOLATE, to connect, See DIAGRAM
NOTE #5: The PCM (Powertrain Control Module) is located on the Passenger side of the engine
compartment, to the passenger side of the battery, below the hood stay, it is in a
104-Pin connector Pin 48.
|