PRINT
HONDA ODYSSEY
MODEL YEAR(S
ODYSSEY 2008-2010
KEY T-HARNESS IMMOBILIZER
N/A N/A HONDA'S TRANPONDER ANTI-THEFT SYSTEM, See NOTE #1
PART COLOR LOCATION DIAGRAM
12 VOLT CONSTANT WHITE (+) @ IGNITION SWITCH, (BROWN, 7-Pin Plug) Pin 3
STARTER BLACK/WHITE (+) @ IGNITION SWITCH, (BROWN, 7-Pin Plug) Pin 1
STARTER 2 N/A
IGNITION 1 BLACK/YELLOW (+) @ IGNITION SWITCH, (BROWN, 7-Pin Plug) Pin 6
IGNITION 2 N/A
IGNITION 3 N/A
ACCESSORY/HEATER BLOWER 1 BLACK/RED (+) @ IGNITION SWITCH, (BROWN, 7-Pin Plug) Pin 4
ACCESSORY/HEATER BLOWER 2 WHITE/RED (+) @ IGNITION SWITCH, (BROWN, 7-Pin Plug) Pin 5
KEYSENSE N/A
PARKING LIGHTS ( - ) RED/BLACK (-) @ WIPER SWITCH, (BLACK/WHITE, 12-Pin Plug) Pin 7
PARKING LIGHTS ( + ) RED/BLACK (+) in DRIVERS KICK PANEL, Harness to Rear of Vehicle
POWER LOCK PINK/BLACK (TYPE B) @ MICU, (LT. GREEN, 30-Pin Plug) Pin 20, NOTE #2
POWER UNLOCK GREEN (TYPE B) @ MICU, (LT. GREEN, 30-Pin Plug) Pin 6, NOTE #2
LOCK MOTOR WIRE YELLOW/BLACK (5-wire type) @ DRIVERS FUSE BOX, (LT. GREEN, 12-Pin Plug) Pin 12
DOOR TRIGGER GREEN (-) in DRIVERS KICK PANEL, Harness to Rear of Vehicle
DOMELIGHT SUPERVISION BLACK/RED (-) @ INTERIOR LIGHT SWITCH on Dash, (GRAY, 6-Pin Plug) Pin 4
TRUNK RELEASE WHITE/BLACK and YELLOW/BLACK , See NOTE #3 @ POWER TAILGATE SWITCH, (LT. GREEN,5-Pin Plug) Pins 2 and 1
SLIDING POWER DOOR N/A
HORN GREEN/YELLOW (-) @ PARKING BRAKE Bracket, (WHITE, 20-Pin Plug) Pin 19
TACH Any wire NOT YELLOW/BLACK (AC) @ Any FUEL-INJECTOR
WAIT TO START LIGHT N/A
BRAKE WHITE/BLACK (+) @ DRIVERS FUSE BOX, (WHITE, 45-Pin Plug) Pin 34
FACTORY ALARM DISARM BLACK/RED to WHITE (-) @ POWER WINDOW MASTER SWITCH, (WHITE, 23-Pin Plug) Pin 21
ANTI-THEFT HONDA'S TRANPONDER ANTI-THEFT SYSTEM, See NOTE #1
NOTES
NOTE #1: HONDA'S TRANSPONDER SYSTEM, Requires Bypass Module:

(For Remote Starting Only) Part #791 Bypass, (Requires Extra Key) for Operation.

(For Remote Starting Only) Part # PK-ALL Bypass. (No Extra Key Required for

Operation) 2-KEYS Required to Program Module.

(For Remote Starting/Door Locks) Part # DB-ALL (No Extra Key Required for Operation)

1-KEY Required for Programming.

To order please go to the SECURITY BYPASS MODULE Page or INTERFACE BYPASS

MODULE Page on this website.







NOTE #2: the MICU (Multiplex Integrated Control Unit) is part of the Driver Fuse Box,

located in the Drivers Kick, it has 2 Plugs on the Right side edge of the Fuse Box.





NOTE #3: these (2) wires SHORT when the POWER TAILGATE Switch is Pressed.
LINK 1 LINK TEXT 1 LINK 2 LINK TEXT 2