PRINT
CHRYSLER SEBRING SEDAN
MODEL YEAR(S
SEBRING SEDAN 2001-2003
KEY T-HARNESS IMMOBILIZER
CHRKEY-1 N/A CHRYSLER'S ANTI-THEFT TRANSPONDER System (GRAY IGNITION KEY), See NOTE #1
PART COLOR LOCATION DIAGRAM
12 VOLT CONSTANT PINK/BLACK (+) and RED (+) @ IGNITION SWITCH HARNESS
STARTER YELLOW (+) @ IGNITION SWITCH HARNESS
STARTER 2 N/A
IGNITION 1 BLUE (+) @ IGNITION SWITCH HARNESS
IGNITION 2 GREEN/RED (+) 20 Gauge wire @ IGNITION SWITCH HARNESS
IGNITION 3 N/A
ACCESSORY/HEATER BLOWER 1 BLACK/ORANGE (+) @ IGNITION SWITCH HARNESS
ACCESSORY/HEATER BLOWER 2 BLACK/WHITE (+) @ IGNITION SWITCH HARNESS
KEYSENSE N/A
PARKING LIGHTS ( - ) N/A
PARKING LIGHTS ( + ) BLACK/YELLOW (+) IN DRIVERS KICK PANEL or HEADLIGHT SWITCH
POWER LOCK WHITE/GREEN (1-Wire Door Lock System), See NOTE #2 @ BCM, C4, Pin 15, See NOTE #3 32591_SEBRING-SEDAN_CHRYSLER SEBRING CONV. 01 and UP 1 WIRE JBS UNITS.pdf
POWER UNLOCK Same wire, See DIAGRAM See DIAGRAM 32591_SEBRING-SEDAN_CHRYSLER SEBRING CONV. 01 and UP 1 WIRE ALERT SHELBY UNITS.pdf
LOCK MOTOR WIRE ORANGE/BLACK (5-WIRE TYPE) @ BCM, C4, Pin 9, See NOTE #3
DOOR TRIGGER See NOTE #5 @ BCM, See NOTE #3 10808_SEBRING-SEDAN_(-) NEGATIVE DOOR PIN ISOLATION CIRCUIT.pdf
DOMELIGHT SUPERVISION TAN (-) @ BCM, Connector 4, Pin 5, See NOTE #3
TRUNK RELEASE BLACK/WHITE (5-Wire), See NOTE #6 @ BCM, Connector 4, Pin 1, See NOTE #3 21499_SEBRING-SEDAN_CHRYSLER SEBRING CONV.TRUNK POP.pdf
SLIDING POWER DOOR N/A
HORN BLACK/RED (-) @ STEERING COLUMN HARNESS
TACH ANY wire that is NOT GREEN/LIGHT GREEN (AC) @ Any COIL or FUEL INJECTOR
WAIT TO START LIGHT N/A
BRAKE WHITE/TAN (+) @ SWITCH ABOVE BRAKE PEDAL
FACTORY ALARM DISARM LIGHT GREEN/ORANGE (+), See NOTE #5 @ BCM, Connector 4, Pin 4, See NOTE #3 23010_SEBRING-SEDAN_CHRYSLER POSITIVE DISARM DIAGRAM.pdf
ANTI-THEFT CHRYSLER'S ANTI-THEFT TRANSPONDER System (GRAY IGNITION KEY), See NOTE #1 @ IGNITION SWITCH TUMBLER
NOTES
NOTE #1: This vehicle may be equipped with CHRYSLER'S ANTI-THEFT TRANSPONDER System

(GRAY IGNITION KEY), if so to remote start will require the 791 BYPASS MODULE and

an extra Ignition key, to order go to the SECURITY BYPASS MODULE PAGE on this

website.









NOTE #2: This vehicle uses a 1-Wire Door Locking System that requires a (+)Positive thru a

1800 Ohm Resistor to LOCK and a (+)Positive thru a 750 Ohm Resistor to UNLOCK,

some units will also require 2 extra relays part #775 to connect, See DIAGRAM







NOTE #3: The BCM (Body Control Module) is located under the DRIVERS SIDE of DASH and is

attached to the FUSE/RELAY box. Connector 4 is a 26 pin plug at the bottom edge of

the BCM.







NOTE #4: this vehicle uses 4 door pin triggers, at the BCM Connector 4, the DRIVERS DOOR is

a TAN (-) Pin 5, the PASSENGERS DOOR is a TAN/RED (-) Pin 6, the DRIVERS REAR

DOOR is a TAN/ORANGE (-) Pin 7 and the PASSENGER REAR DOOR is a TAN/YELLOW,

Pin 8. When connecting to an alarm system use all 4 wires and DIODE ISOLATE,

See DIAGRAM.







NOTE #5; To DISARM requires a (+)Positive thru a 750 Ohm Resistor and an extra Relay part

#775, to connect, See DIAGRAM







NOTE #6: the TRUNK/HATCH Release on this vehicle is a 5-Wire System and will require an

extra Relay Part #775, to connect, See DIAGRAM.
LINK 1 LINK TEXT 1 LINK 2 LINK TEXT 2