PRINT
FORD EXCURSION
MODEL YEAR(S
EXCURSION 2003
KEY T-HARNESS IMMOBILIZER
FDKEY-1 N/A FORDS TRANSPONDER ANTI-THEFT SYSTEM, See NOTE #1
PART COLOR LOCATION DIAGRAM
12 VOLT CONSTANT YELLOW (+) and LIGHT GREEN/PURPLE (+) IGNITION SWITCH HARNESS
STARTER GREEN (+) IGNITION SWITCH HARNESS
STARTER 2 N/A
IGNITION 1 RED/LIGHT GREEN (+) or WHITE/YELLOW (+) IGNITION SWITCH HARNESS
IGNITION 2 RED/BLACK (+) IGNITION SWITCH HARNESS
IGNITION 3 N/A
ACCESSORY/HEATER BLOWER 1 GRAY/YELLOW (+) IGNITION SWITCH HARNESS
ACCESSORY/HEATER BLOWER 2 BLACK/LIGHT GREEN (+) IGNITION SWITCH HARNESS
KEYSENSE N/A
PARKING LIGHTS ( - ) N/A
PARKING LIGHTS ( + ) BROWN (+) @ HEADLIGHT SWITCH
POWER LOCK WHITE/RED (TYPE B) @ VSM, See NOTE #2
POWER UNLOCK BLACK/WHITE (TYPE B) @ VSM, See NOTE #2
LOCK MOTOR WIRE PINK/BLACK (+) @ VSM, See NOTE #2
DOOR TRIGGER BLACK/LIGHT BLUE (+) IN EITHER KICK PANEL
DOMELIGHT SUPERVISION USE DOOR TRIGGER
TRUNK RELEASE N/A
SLIDING POWER DOOR N/A
HORN BLUE (-) @ STEERING COLUMN HARNESS
TACH See NOTE #3 @ IGNITION COIL PACK
WAIT TO START LIGHT See NOTE #4
BRAKE LIGHT GREEN (+) @ SWITCH ABOVE BRAKE PEDAL
FACTORY ALARM DISARM N/A
ANTI-THEFT FORDS TRANSPONDER ANTI-THEFT SYSTEM, See NOTE #1 @ IGNITION SWITCH TUMBLER
NOTES
NOTE #1: This vehicle is equipped with a Special Anti-theft key, to remote start you will need a

Bypass module 791,(use this module IF you have a extra ignition key to place inside

the 791 to remote start, if you do not have an extra key to use or wish not to have a

key placed inside this bypass module, we OFFER a KEYLESS INTERFACE BYPASS

MODULE that does not require a key to be placed inside the bypass modlue, this is

Part # PKALL or PKFM, either one will work, to order, go to the INTERFACE BYPASS

MODULE PAGE on this website.









NOTE #2: The VSM (Vehicle Security Module) is located to the RIGHT of the Gas Pedal, just

above the transmission hump below the Radio, it is not accessible from the radio

opening.







NOTE #3; At the COIL PACK use the wire that is NOT RED/LIGHT GREEN.







NOTE #4: The DIESEL TACH wire is a GREEN/WHITE wire in a 5-wire harness held up with WHITE

tape behind the parking Brake release. DO NOT USE the WAIT TO START WIRE, you

will need to program the Remote Starter for the WAIT to START TIMER MODE for the

DIESEL Start to work properly.
LINK 1 LINK TEXT 1 LINK 2 LINK TEXT 2