PRINT
CHRYSLER CONCORDE
MODEL YEAR(S
CONCORDE 2004
KEY T-HARNESS IMMOBILIZER
CHRKEY-1 N/A CHRYSLER'S ANTI-THEFT TRANSPONDER System, See NOTE #1
PART COLOR LOCATION DIAGRAM
12 VOLT CONSTANT PINK/BLACK (+) and RED (+) @ IGNITION SWITCH HARNESS
STARTER YELLOW (+) @ IGNITION SWITCH HARNESS
STARTER 2 N/A
IGNITION 1 DARK BLUE/WHITE (+) @ IGNITION SWITCH HARNESS
IGNITION 2 DARK GREEN/RED (+) @ IGNITION SWITCH HARNESS
IGNITION 3 N/A
ACCESSORY/HEATER BLOWER 1 BLACK/ORANGE (+) @ IGNITION SWITCH HARNESS
ACCESSORY/HEATER BLOWER 2 BLACK/WHITE (+) @ IGNITION SWITCH HARNESS
KEYSENSE N/A
PARKING LIGHTS ( - ) YELLOW (-) See NOTE #2 @ HEADLIGHT SWITCH, See DIAGRAM 32277_CONCORDE_CHRYSLER PARKING LIGHT DIAGRAM.pdf
PARKING LIGHTS ( + ) BLACK/YELLOW (+) @ BACK of JUNCTION BLOCK, GRAY Plug, Pin 11
POWER LOCK WHITE/DARK GREEN (1-Wire Door Lock System) See NOTE #3 @ BCM, BLUE Plug, Pin 5, See NOTE #4 14301_CONCORDE_CHRYSLER COUPE and SEDAN 1 WIRE JBS UNITS.pdf
POWER UNLOCK Same wire, See DIAGRAM See DIAGRAMS 15941_CONCORDE_CHRYSLER COUPE and SEDAN 1 WIRE ALERT SHELBY UNITS.pdf
LOCK MOTOR WIRE ORANGE (5-wire) @ BACK of JUNCTION BLOCK, BROWN Plug, Pin 3
DOOR TRIGGER See NOTE #6 @ BCM BLUE PLUG, See NOTE #4 26500_CONCORDE_(-) NEGATIVE DOOR PIN ISOLATION CIRCUIT.pdf
DOMELIGHT SUPERVISION YELLOW (-), (Requires #775 Relay) @ FRONT of JUNCTION BLOCK, BROWN Plug Pin 4
TRUNK RELEASE BLACK/WHITE (+) @ TRUNK RELEASE SWITCH
SLIDING POWER DOOR N/A
HORN BLACK/RED (-) @ BACK of JUNCTION BLOCK, GRAY Plug, Pin 6
TACH See NOTE #5 @ IGNITION COIL PACK
WAIT TO START LIGHT N/A
BRAKE WHITE/TAN (+) @ SWITCH ABOVE BRAKE PEDAL
FACTORY ALARM DISARM LIGHT GREEN/ORANGE (+) See NOTE #7 @ BCM. BLUE Plug, Pin 13, See NOTE #4 15941_CONCORDE_CHRYSLER POSITIVE DISARM DIAGRAM.pdf
ANTI-THEFT CHRYSLER'S ANTI-THEFT TRANSPONDER System, See NOTE #1 TRANSPONDER @ IGNITION SWITCH TUMBLER
NOTES
NOTE #1: This vehicle may be equipped with CHRYSLER'S ANTI-THEFT TRANSPONDER System

(GRAY IGNITION KEY), if so to remote start will require the 791 BYPASS MODULE and

an extra Ignition key, to order go to the SECURITY BYPASS MODULE PAGE on this

website.









NOTE #2: the PARKING LIGHTS require an extra relay Part #775 and a (-)Negative thru a 47

Ohm Resistor, to connect, See DIAGRAM





NOTE #3: the DOOR LOCKS on this vehicle require a (+)Positive thru a 2700 Ohm resistor to

LOCK and a (+)Positive thru a 620 Ohm resistor to UNLOCK, some units will also

require 2 extra relays part #775 for the keyless entry feature to function, See

DIAGRAMS.You can also get a INTERFACE BYPASS MODULE the Part # XK09 that will

do this for you without adding extra relays and resistors, these Modules will also do

dome light supervision and trunk pop with nothing needed, to order please go to the

INTERFACE BYPASS MODULE Page on this website









NOTE #4: The BCM (Body Control Module) is located on the LEFT SIDE of the dash attached to

the JUNCTION BLACK.







NOTE #5: This vehicle uses a Multi-Coil system, for TACH use any wire at the coil pack that is

NOT DARK GREEN/LIGHT GREEN







NOTE #6: the DRIVERS DOOR is a TAN (-) PIN 4, the PASSENGER DOOR is a TAN/RED (-) PIN 2,

the DRIVERS REAR DOOR is a TAN/RED (-) PIN 1 and the PASSENGER REAR DOOR is a

TAN/RED (-) PIN 10. When connecting to an ALARM SYSTEM, use all 4 wires and

DIODE ISOLATE See DIAGRAM







NOTE #7: the DISARM wire requires an extra relay part #775 and a (+)Positive thru a 680 Ohm

Resistor, to connect, See DIAGRAM.
LINK 1 LINK TEXT 1 LINK 2 LINK TEXT 2