PRINT
FORD EXPEDITION
MODEL YEAR(S
EXPEDITION 1999-2002
KEY T-HARNESS IMMOBILIZER
FDKEY-1 N/A FORD'S ANTI-THEFT SYSTEM, TRANSPONDER, SEE NOTE #1
PART COLOR LOCATION DIAGRAM
12 VOLT CONSTANT YELLOW (+) and LIGHT GREEN/PURPLE (+) @ IGNITION SWITCH HARNESS
STARTER RED/LIGHT BLUE (+) @ IGNITION SWITCH HARNESS
STARTER 2 N/A
IGNITION 1 BLUE/LIGHT GREEN (+) @ IGNITION SWITCH HARNESS
IGNITION 2 RED/BLACK (+) @ IGNITION SWITCH HARNESS
IGNITION 3 N/A
ACCESSORY/HEATER BLOWER 1 GREY/YELLOW (+) @ IGNITION SWITCH HARNESS
ACCESSORY/HEATER BLOWER 2 BLACK/LIGHT GREEN (+) @ IGNITION SWITCH HARNESS
KEYSENSE N/A
PARKING LIGHTS ( - ) N/A
PARKING LIGHTS ( + ) BROWN (+) @ HEADLIGHT SWITCH
POWER LOCK PINK/YELLOW (TYPE B) @ KEYLESS ENTRY MODULE, See NOTE #2
POWER UNLOCK PINK/LIGHT GREEN (TYPE B) @ KEYLESS ENTRY MODULE, See NOTE #2
LOCK MOTOR WIRE PINK/BLACK (+) IN DRIVERS KICK PANEL
DOOR TRIGGER LIGHT BLUE/WHITE (-), See NOTE #4 @ KEYLESS ENTRY MODULE, See NOTE #2
DOMELIGHT SUPERVISION BLACK/LIGHT BLUE (+) IN PASSENGER KICK PANEL
TRUNK RELEASE N/A
SLIDING POWER DOOR N/A
HORN DARK BLUE (-) @ STEERING COLUMN HARNESS
TACH See NOTE #5
WAIT TO START LIGHT N/A
BRAKE LIGHT GREEN (+) @ SWITCH ABOVE BRAKE PEDAL
FACTORY ALARM DISARM N/A
ANTI-THEFT FORD'S ANTI-THEFT TRANSPONDER SYSTEM, SEE NOTE #1 @ IGNITION SWITCH TUMBLER
NOTES
NOTE #1: This vehicle is equipped with a Special Anti-theft key, to remote start you will need a

Bypass module 791,(use this module IF you have a extra ignition key to place inside

the 791 to remote start, if you do not have an extra key to use or wish not to have a

key placed inside this bypass module, we OFFER a KEYLESS INTERFACE BYPASS

MODULE that does not require a key to be placed inside the bypass modlue, this is

Part # PKALL or PKFM, either one will work, to order, go to the INTERFACE BYPASS

MODULE PAGE on this website.







NOTE #2: The KEYLESS ENTRY MODULE is located high in the DRIVERS KICK PANEL against

the FIREWALL.





NOTE #3: At the FIREWALL on the DRIVERS SIDE you will find (3) WIRE HARNESSES, the

TACH wire will be located in the UPPER WIRE HARNESS.





NOTE #4: The LIGHT BLUE/WHITE wire is in Pin-11, next to the BLACK/PINK wire. Test this

wire with a DIGITAL MULTI-METER ONLY, as to not damage the circuit.





NOTE #5: The TACH wire on the 4.6L engine is a PINK/WHITE in a 3-Pin plug at the front of the

engine below the Air intake. On the 5.4L engine the TACH wire is a LIGHT

GREEN/WHITE at the coil on the passenger side of the engine.
LINK 1 LINK TEXT 1 LINK 2 LINK TEXT 2