PRINT
NISSAN 240SX
MODEL YEAR(S
240SX 1995-1998
KEY T-HARNESS IMMOBILIZER
N/A NIS-1 N/A
PART COLOR LOCATION DIAGRAM
12 VOLT CONSTANT WHITE (+) IGNITION SWITCH HARNESS
STARTER BLACK/YELLOW (+) See NOTE *1 IGNITION SWITCH HARNESS
STARTER 2 BLACK/WHITE (+) See NOTE *1 IGNITION SWITCH HARNESS
IGNITION 1 BLACK/RED (+) IGNITION SWITCH HARNESS
IGNITION 2 N/A
IGNITION 3 N/A
ACCESSORY/HEATER BLOWER 1 WHITE (+) See NOTE *2 IGNITION SWITCH HARNESS 12318_240SX_NISSAN ACCESSORY ISOLATION CIRCUIT.pdf
ACCESSORY/HEATER BLOWER 2 N/A
KEYSENSE N/A
PARKING LIGHTS ( - ) N/A
PARKING LIGHTS ( + ) RED/BLUE (+) @ STEERING COLUMN HARNESS
POWER LOCK LIGHT GREEN/WHITE (TYPE B) @ ANTI-THEFT MODULE, See NOTE *1
POWER UNLOCK BROWN (TYPE B) @ ANTI-THEFT MODULE, See NOTE *1
LOCK MOTOR WIRE N/A
DOOR TRIGGER RED/WHITE (-) IN DRIVERS KICK PANEL
DOMELIGHT SUPERVISION USE DOOR TRIGGER Requires Part #775 Relay
TRUNK RELEASE N/A
SLIDING POWER DOOR N/A
HORN YELLOW/GREEN (-) @ ANTI-THEFT MODULE, See NOTE *3
TACH YELLOW/RED @ ECM, IN PASSENGER KICK PANEL
WAIT TO START LIGHT N/A
BRAKE RED/GREEN (+) @ SWITCH ABOVE BRAKE PEDAL
FACTORY ALARM DISARM GREEN/YELLOW (-) @ ANTI-THEFT MODULE, See NOTE *1
ANTI-THEFT N/A
NOTES
NOTE *1 When Installing a REMOTE STARTER, you MUST use BOTH Starter #1 and Starter #2 wires. Both wires must be connected to the STARTER/CRANKING Output wire from the Remote Starter or the vehcile will NOT Remote Start when the Engine is cold.





NOTE *2 WHEN INSTALLING A REMOTE STARTER TO THIS VEHICLE, AN EXTRA RELAY PART #775 IS NEEDED TO ISOLATE THE ACCESSORY WIRE, TO CONNECT, See DIAGRAM: 240SX NISSAN ACCESSORY ISOLATION CIRCUIT.







NOTE *3 THE ANTI-THEFT MODULE IS LOCATED JUST ABOVE HOOD RELEASE CABLE, IN THE DRIVERS KICK PANEL.
LINK 1 LINK TEXT 1 LINK 2 LINK TEXT 2