PRINT
DODGE SPRINTER
MODEL YEAR(S
SPRINTER 2003-2007
KEY T-HARNESS IMMOBILIZER
N/A N/A CHRYSLER'S TRANSPONDER ANTI-THEFT SYSTEM, See NOTE #1
PART COLOR LOCATION DIAGRAM
12 VOLT CONSTANT RED (+) @ IGNITION SWITCH HARNESS
STARTER BLACK/YELLOW (+) @ IGNITION SWITCH HARNESS
STARTER 2 N/A
IGNITION 1 BLACK (+) @ IGNITION SWITCH HARNESS
IGNITION 2 BLACK/RED (+) @ IGNITION SWITCH HARNESS
IGNITION 3 N/A
ACCESSORY/HEATER BLOWER 1 GRAY/DARK GREEN (+) @ IGNITION SWITCH HARNESS
ACCESSORY/HEATER BLOWER 2 N/A
KEYSENSE N/A
PARKING LIGHTS ( - ) N/A
PARKING LIGHTS ( + ) GRAY/BLACK (+) and GRAY/RED (+) Use both, See NOTE #2 @ FUSEBOX, BLACK 15 Pin plug, Pins 4 and 6 6617_SPRINTER_DUAL PARKING LIGHT DIAGRAM.pdf
POWER LOCK WHITE/YELLOW (TYPE B), See NOTE #3 @ SWITCH on DASH or CTM, PINK Plug, Pin 7, See NOTE #4
POWER UNLOCK WHITE/YELLOW (TYPE B), See NOTE #3 @ SWITCH on DASH or CTM, PINK Plug Pin 7, See NOTE #4
LOCK MOTOR WIRE N/A
DOOR TRIGGER BROWN/WHITE (-) IN DRIVERS DOOR HARNESS
DOMELIGHT SUPERVISION USE DOOR TRIGGER, (Requires Part #775 Relay)
TRUNK RELEASE N/A
SLIDING POWER DOOR N/A
HORN BLACK/YELLOW (-) @ STEERING COLUMN HARNESS
TACH DARK GREEN/YELLOW (AC) @ DATA LINK CONNECTOR, Pin 3, See NOTE #5
WAIT TO START LIGHT N/A
BRAKE BLACK/RED (+) @ SWITCH ABOVE BRAKE PEDAL, See NOTE #6
FACTORY ALARM DISARM BLACK (-) IN DRIVERS KICK PANEL
ANTI-THEFT CHRYSLER'S TRANSPONDER ANTI-THEFT SYSTEM, See NOTE #1 @ IGNITION SWITCH TUMBLER
NOTES
NOTE #1: This vehicle may be equipped with CHRYSLER'S ANTI-THEFT TRANSPONDER System

(GRAY IGNITION KEY), if so to remote start will require the 791 BYPASS MODULE and

an extra Ignition key, to order go to the SECURITY BYPASS MODULE PAGE on this

website.







NOTE #2: the PARKING LIGHTS are a 2-Wire System and will require 2 extra Relays part #775,

to connect, See DIAGRAM







NOTE #3: a (-)Negative pulse on this wire will alternate between LOCK and UNLOCK. Use

DIODES on the LOCK and UNLOCK outputs from the unit if the unit you are using

does not have on board Door Lock Relays and wire in as a TYPE B tie both wires to this

wire in the vehicle.





NOTE #4: the CTM (Central Timmer Module) is located under the drivers seat.







NOTE #5: the DATA LINK Connector is under the DRIVERS SIDE of DASH.





NOTE #6: the BRAKE LIGHT will only test with ignition on.
LINK 1 LINK TEXT 1 LINK 2 LINK TEXT 2