|
PART
|
COLOR
|
LOCATION
|
DIAGRAM
|
|
12 VOLT CONSTANT
|
Connect to BATTERY ONLY
|
|
|
|
STARTER
|
PINK/ORANGE (+)
|
@ IGNITION SWITCH HARNESS
|
|
|
STARTER 2
|
See NOTE #1
|
|
|
|
IGNITION 1
|
PINK/LIGHT GREEN (+)
|
@ IGNITION SWITCH HARNESS
|
|
|
IGNITION 2
|
N/A
|
|
|
|
IGNITION 3
|
N/A
|
|
|
|
ACCESSORY/HEATER BLOWER 1
|
See NOTE #1
|
|
|
|
ACCESSORY/HEATER BLOWER 2
|
N/A
|
|
|
|
KEYSENSE
|
N/A
|
|
|
|
PARKING LIGHTS ( - )
|
N/A
|
|
|
|
PARKING LIGHTS ( + )
|
DO NOT USE!
|
|
|
|
POWER LOCK
|
PURPLE/DARK GREEN (1-Wire System) See NOTE #2
|
IN DRIVERS KICK PANEL or Cluster Connector 3, pin 17 See DIAGRAM
|
14301_GRAND-CHEROKEE_GRAND CHEROKEE 1 WIRE JBS UNIT.pdf
|
|
POWER UNLOCK
|
Same wire, See DIAGRAM
|
See NOTE #2, See DAIGRAM
|
14301_GRAND-CHEROKEE_GRAND CHEROKEE 1 WIRE ALERT SHELBY UNITS.pdf
|
|
LOCK MOTOR WIRE
|
LIGHT GREEN/LIGHT BLUE (5-WIRE TYPE)
|
@ PLUG ABOVE FUSES, PIN 36
|
|
|
DOOR TRIGGER
|
See NOTE #3
|
IN EACH KICK PANEL
|
|
|
DOMELIGHT SUPERVISION
|
YELLOW/ORANGE (-), Requires Part #775 Relay
|
@ ANY UNDERDASH LIGHT
|
|
|
TRUNK RELEASE
|
ORANGE/PURPLE (-) See NOTE #4 Requires Part #775 Relay
|
IN DRIVERS KICK PANEL
|
|
|
SLIDING POWER DOOR
|
N/A
|
|
|
|
HORN
|
DARK GREEN/ORANGE (+)
|
@ HORN or IPM, Connector, C2 pin 35, See NOTE #5
|
|
|
TACH
|
ANY wire NOT RED/TAN or DARK GREEN/LIGHT GREEN
|
@ any FUEL-INJECTOR or IGNITION COIL
|
|
|
WAIT TO START LIGHT
|
N/A
|
|
|
|
BRAKE
|
WHITE/TAN (+) or WHITE/LIGHT GREEN (+)
|
@ SWITCH ABOVE BRAKE PEDAL
|
|
|
FACTORY ALARM DISARM
|
N/A
|
|
|
|
ANTI-THEFT
|
CHRYSLER'S MULTIPLEX IGNITION/TRANSPONDER SYSTEM, SEE NOTE #1
|
|
|
|
NOTES
|
NOTE #1: This vehicle requires a speciall INFERFACE BYPASS MODULE for REMOTE STARTING PART #DBALL2($99) or XK09($78) BYPASS MODULE, to order either module Call Tech Support 800 561 1110 ex. 2146,
NOTE #2: vehicles with MEMORY SEATS, have to go to the DRIVERS MEMORY MIRRO MODULE in the door to get this wire. The LOCK wire requires a (-)Negative thru 330 Ohm resistor and UNLOCK requires a (-)Negative thru a 100 Ohm resistor, some units require 2 extra relays part #775, to connect. See DIAGRAM
NOTE #3: the DRIVERS DOOR is a PURPLE (-) PIN 6, the PASSENGER DOOR is a PURPLE/WHITE (-) PIN 7, the DRIVERS REAR DOOR is a PURPLE/GRAY (-) PIN 4, and the PASSENGER REAR DOOR is a PURPLE/YELLOW (-) PIN 5, when connecting an ALARM SYSTEM, use all 4 DOOR TRIGGER wires and DIODE ISOLATE, to connect, See DIAGRAM.
NOTE #4: when testing the TRUNK/HATCH RELEASE wire, you must use the Key to open the REAR GLASS, this wire should then show a (-) Negative during testing.
NOTE #5: the IPM (Integrated Power Module) is located on the DRIVERS FENDER, BEHIND THE BATTERY.
|