PRINT
HONDA FIT
MODEL YEAR(S
FIT 2007-2008
KEY T-HARNESS IMMOBILIZER
N/A N/A HONDA'S TRANSPONDER ANTI-THEFT SYSTEM, SEE NOTE #1
PART COLOR LOCATION DIAGRAM
12 VOLT CONSTANT WHITE (+) @ IGNITION SWITCH HARNESS
STARTER BLACK/WHITE (+) @ IGNITION SWITCH HARNESS
STARTER 2 N/A
IGNITION 1 BLACK/YELLOW (+) @ IGNITION SWITCH HARNESS
IGNITION 2 N/A
IGNITION 3 N/A
ACCESSORY/HEATER BLOWER 1 YELLOW/BLACK (+) @ IGNITION SWITCH HARNESS
ACCESSORY/HEATER BLOWER 2 WHITE/RED (+) @ IGNITION SWITCH HARNESS
KEYSENSE N/A
PARKING LIGHTS ( - ) BLUE (-) @ HEADLIGHT SWITCH or GCM, 40-Pin Plug, Pin 19 See NOTE #2
PARKING LIGHTS ( + ) RED/BLACK (+) @ FUSE BOX, 14-Pin Plug, Pin 5
POWER LOCK WHITE/GREEN (TYPE B) in DRIVERS KICK PANEL or GCM, 40-Pin Plug, Pin 9, See NOTE #2
POWER UNLOCK WHITE/BLUE (TYPE B) in DRIVERS KICK PANEL or GCM, 40-Pin Plug, Pin 10, See NOTE #2
LOCK MOTOR WIRE WHITE/BLACK (5-WIRE TYPE) @ FUSE BOX, GREEN 8-Pin Plug, Pin 2
DOOR TRIGGER GREEN (-) (Drivers Door), PURPLE (-) (Passenger Door) Use both, See DIAGRAM in EACH KICK PANEL, or GCM, 20-Pin Plug, Pins 13 and 14 See NOTE #2 14301_FIT_(-) NEGATIVE DOOR PIN ISOLATION CIRCUIT.pdf
DOMELIGHT SUPERVISION GREEN/RED (-), (Requires Part #775 Relay) @ FUSE BOX or GCM, 20-Pin Plug, Pin 12 See NOTE #2
TRUNK RELEASE N/A
SLIDING POWER DOOR N/A
HORN ORANGE (-) @ HORN SWITCH or GCM, 14-Pin Plug, Pin 8 See NOTE #2
TACH GREEN/ORANGE (AC) @ FUSE BOX, 6-Pin Plug, Pin 2
WAIT TO START LIGHT N/A
BRAKE WHITE/BLACK (+) @ SWITCH ABOVE BRAKE PEDAL or FUSE BOX, 14-Pin Plug, Pin 4
FACTORY ALARM DISARM WHITE (-), See NOTE #4 in DRIVERS KICK PANEL or SCU, 20-Pin Plug, Pin 3 See NOTE #3
ANTI-THEFT HONDA'S TRANSPONDER ANTI-THEFT System, SEE NOTE #1 @ IGNITION SWITCH TUMBLER
NOTES
NOTE #1: HONDA'S TRANSPONDER SYSTEM, Requires Bypass Module:

(For Remote Starting Only) Part #791 Bypass, (Requires Extra Key) for Operation.

(For Remote Starting Only) Part # PK-ALL Bypass. (No Extra Key Required for

Operation) 2-KEYS Required to Program Module.

(For Remote Starting Only) Part # DB-ALL (No Extra Key Required for Operation)

1-KEY Required for Programming.

To order please go to the SECURITY BYPASS MODULE Page or INTERFACE BYPASS

MODULE Page on this website.









NOTE #2: the GCM (Gauge Control Module) is located inside the Instrument Cluster

on this vehicle.







NOTE #3; the SCU (Security Control Unit) is located under the Drivers Side of the Dash.







NOTE #4: Test this wire while turning the Key in the Drivers Door Key Cylinder.





LINK 1 LINK TEXT 1 LINK 2 LINK TEXT 2