PRINT
OLDSMOBILE CUTLASS CRUISER
MODEL YEAR(S
CUTLASS CRUISER 1994-1995
KEY T-HARNESS IMMOBILIZER
N/A GM-3 N/A
PART COLOR LOCATION DIAGRAM
12 VOLT CONSTANT RED (+) IGNITION SWITCH HARNESS
STARTER PURPLE (+) or YELLOW (+) IGNITION SWITCH HARNESS
STARTER 2 N/A
IGNITION 1 PINK (+) IGNITION SWITCH HARNESS
IGNITION 2 N/A
IGNITION 3 N/A
ACCESSORY/HEATER BLOWER 1 ORANGE (+) IGNITION SWITCH HARNESS
ACCESSORY/HEATER BLOWER 2 N/A
KEYSENSE N/A
PARKING LIGHTS ( - ) N/A
PARKING LIGHTS ( + ) BROWN (+) @ STEERING COLUMN
POWER LOCK LIGHT BLUE (TYPE A) See NOTE *1
POWER UNLOCK WHITE (TYPE A) See NOTE *1
LOCK MOTOR WIRE GRAY (+) IN DRIVERS DOOR HARNESS
DOOR TRIGGER See NOTE *2 IN EACH KICK PANEL 29358_CUTLASS-CRUISER_(-) NEGATIVE DOOR PIN ISOLATION CIRCUIT.pdf
DOMELIGHT SUPERVISION WHITE (-), Requires Part #775 Relay @ UNDERDASH LIGHT
TRUNK RELEASE BLACK (+), Requires Part #775 Relay @ TRUNK RELEASE SWITCH
SLIDING POWER DOOR N/A
HORN BLACK (-) @ STEERING COLUMN HARNESS
TACH See NOTE *3 @ COIL PACK
WAIT TO START LIGHT N/A
BRAKE YELLOW (+) or WHITE (+) @ SWITCH ABOVE BRAKE PEDAL
FACTORY ALARM DISARM N/A
ANTI-THEFT N/A
NOTES
NOTE *1 the LOCK and UNLOCK wires are located near the UNDERDASH LIGHT in a 3 and 8 pin plug.





NOTE *2 this vehicle has a GREEN/BLACK (-) for the DRIVERS DOOR in the drivers kick panel and a LIGHT BLUE (-) for the PASSENGER DOOR in the passenger kick panel. When connecting to an ALARM SYSTEM, you need to tie into the Rear doors for a door trigger, use the wires at each pin switch and DIODE ISOLATE. to connect, See DIAGRAM.





NOTE *3 on the 4 Cylinder engine, use a WHITE or ORANGE wire, on the V-6 engine, use the PURPLE/WHITE wire.
LINK 1 LINK TEXT 1 LINK 2 LINK TEXT 2