PRINT
INFINITI FX45
MODEL YEAR(S
FX45 2003-2005
KEY T-HARNESS IMMOBILIZER
N/A N/A INFINITI'S TRANSPONDER ANTI-THEFT SYSTEM, Requires Bypass Module, See NOTE #1
PART COLOR LOCATION DIAGRAM
12 VOLT CONSTANT BLUE/RED to RED (+) @ IGNITION SWITCH HARNESS
STARTER BLUE (+) See NOTE #2 @ IGNITION SWITCH HARNESS
STARTER 2 PINK (+), See NOTE #2 @ IGNITION SWITCH HARNESS
IGNITION 1 BLACK (+) @ IGNITION SWITCH HARNESS
IGNITION 2 N/A
IGNITION 3 N/A
ACCESSORY/HEATER BLOWER 1 WHITE (+) @ IGNITION SWITCH HARNESS
ACCESSORY/HEATER BLOWER 2 N/A
KEYSENSE BLACK/WHITE (+)(Required) @ IGNITION SWITCH HARNESS
PARKING LIGHTS ( - ) N/A
PARKING LIGHTS ( + ) RED to WHITE (+) WHITE 16-PIN PLUG, Above DRIVERS KICK PANEL
POWER LOCK PINK (TYPE B), See NOTE #4 @ DRIVERS DOOR MODULE, in DOOR
POWER UNLOCK ORANGE (TYPE B) Double Pulse required, See NOTE #4 @ DRIVERS DOOR MODULE, in DOOR
LOCK MOTOR WIRE PURPLE or PURPLE/WHITE (5-WIRE TYPE) BLACK PLUG, PIN 50, @ BCM, See NOTE #3
DOOR TRIGGER See NOTE #5 @ BCM, See NOTE #3
DOMELIGHT SUPERVISION PURPLE/WHITE (-) BLACK PLUG, PIN 48, @ BCM, See NOTE #3
TRUNK RELEASE N/A
SLIDING POWER DOOR N/A
HORN GREEN/BLACK to LT.BLUE (-) @ HORN SWITCH in Column
TACH Any wire NOT BLACK or WHITE (AC) @ Any FUEL-INJECTOR
WAIT TO START LIGHT N/A
BRAKE PINK (+) @ BRAKE PEDAL SWITCH
FACTORY ALARM DISARM N/A
ANTI-THEFT INFINITI'S TRANSPONDER ANTI-THEFT SYSTEM, Requires Bypass Module, See NOTE #1
NOTES
NOTE #1 This vehicle is Equipped with a TRANPONDER ANTI-THEFT System that will requires a Bypass Module for REMOTE STARTING:



Part # 791 Bypass Module will work IF you have another IGNITION key that you can give up, this key will need to be placed inside the 791 Bypass Module and be left there for Remote Starting.





Part # DB-ALL or XK09 is a Keyless Bypass Module used for Remote Starting that DOES NOT require a Key to be left inside the bypass module. NOTE on the 2005 model year, if using the DB-ALL this module will also do Keyless entry and trunk release. To order go to the INTERFACE BYPASS MODULE PAGE on this website.







NOTE #2: When Installing a REMOTE STARTER, you MUST use BOTH Starter #1 and Starter #2 wires. Both wires must be connected to the STARTER/CRANKING Output wire from the Remote Starter or the vehcile will NOT Remote Start when the Engine is cold.





NOTE #3 THE BCM (BODY CONTROL MODULE) IS IN THE DRIVER KICK PANEL







NOTE #4 TEST THESES WIRES WHILE TUNING THE KEY IN THE DRIVERS DOOR KEY CYLINDER.







NOTE #5 THE DRIVERS DOOR IS A WHITE (-) IN PIN 62, THE DRIVERS REAR DOOR IS A PINK (-) PIN 63, THE PASSENGER DOORS ARE IN A WHITE 40 PIN PLUG. THE PASSENGER DOOR IS A PINK/BLACK (-) PIN 12, AND THE PASSENGER REAR IS A PINK/BLUE (-) PIN 13 ALL WIRES ARE AT THE BCM. WHEN CONNECTING TO AN ALARM SYSTEM, USE ALL 4 DOOR TRIGGER WIRES AND DIODE ISOLATE, TO CONNECT, See DIAGRAM.
LINK 1 LINK TEXT 1 LINK 2 LINK TEXT 2