MAKE ACURA ALFA ROMEO AUDI BMW BUICK CADILLAC CHEVROLET CHRYSLER DAEWOO DODGE EAGLE FIAT FORD GEO GMC HARLEY-DAVIDSON HONDA HONDA MC HUMMER HYUNDAI INFINITI ISUZU JAGUAR JEEP KAWASAKI MC KIA LAND ROVER LEXUS LINCOLN MAZDA MERCEDES BENZ MERCURY MINI MITSUBISHI NISSAN OLDSMOBILE PLYMOUTH PONTIAC PORSCHE RAM SAAB SATURN SCION SMART CAR SUBARU SUZUKI SUZUKI MC TOYOTA VOLKSWAGEN VOLVO

PRINT

CHRYSLER 300M

MODEL	YEAR(S
300M	1999-2003

KEY	T-HARNESS	IMMOBILIZER
CHRKEY-1	N/A	CHRYSLER'S ANTI-THEFT TRANSPONDER System, See NOTE #1

PART	COLOR	LOCATION	DIAGRAM
12 VOLT CONSTANT	PINK/BLACK (+) or RED (+)	@ IGNITION SWITCH HARNESS
STARTER	YELLOW (+)	@ IGNITION SWITCH HARNESS
STARTER 2	N/A
IGNITION 1	DARK BLUE/WHITE (+)	@ IGNITION SWITCH HARNESS
IGNITION 2	GREEN/RED (+)	@ IGNITION SWITCH HARNESS
IGNITION 3	N/A
ACCESSORY/HEATER BLOWER 1	BLACK/ORANGE (+)	@ IGNITION SWITCH HARNESS
ACCESSORY/HEATER BLOWER 2	N/A
KEYSENSE	N/A
PARKING LIGHTS ( - )	YELLOW (-), See NOTE #2	@ HEADLIGHT SWITCH, See DIAGRAM	24464_300M_CHRYSLER PARKING LIGHT DIAGRAM.pdf
PARKING LIGHTS ( + )	N/A
POWER LOCK	WHITE/GREEN (1-Wire Door System), See NOTE #3	@ BACK of FUSEBOX, See DIAGRAM	30347_300M_CHRYSLER COUPE and SEDAN 1 WIRE JBS UNITS.pdf
POWER UNLOCK	Same wire, See DIAGRAM	See DIAGRAMS	12382_300M_CHRYSLER COUPE and SEDAN 1 WIRE ALERT SHELBY UNITS.pdf
LOCK MOTOR WIRE	ORANGE (5-wire type)	@ BCM, See NOTE #4
DOOR TRIGGER	TAN (-) and TAN/RED (-) use both, See NOTE #7	@ BCM, See NOTE #4	26500_300M_(-) NEGATIVE DOOR PIN ISOLATION CIRCUIT.pdf
DOMELIGHT SUPERVISION	YELLOW (-), (Requires #775 Relay)	@ REAR of FUSEBOX, in a BROWN Plug
TRUNK RELEASE	BLACK/WHITE (+), (Requires #775 Relay)	@ TRUCK RELEASE SWITCH
SLIDING POWER DOOR	N/A
HORN	BLACK/RED (-)	@ STEERING COLUMN HARNESS
TACH	See NOTE #5
WAIT TO START LIGHT	N/A
BRAKE	WHITE/TAN (+)	@ SWITCH ABOVE BRAKE PEDAL
FACTORY ALARM DISARM	LIGHT GREEN/ORANGE (+), See NOTE #6	IN DRIVERS KICK PANEL, See DIAGRAM	14301_300M_CHRYSLER POSITIVE DISARM DIAGRAM.pdf
ANTI-THEFT	CHRYSLER'S SENTRY ANTI-THEFT TRANSPONDER System, See NOTE #1	@ IGNITION SWITCH TUMBLER

NOTES

NOTE #1: This vehicle is equipped with CHRYSLER'S TRANSPONDER ANTI-THEFT SYSTEM and will require the 791 bypass module and and extra ignition key for remote starting only. to order go to the SECURITY BYPASS MODULE Page on this website. NOTE #2: the PARKING LIGHTS on this vehicle Require an extra Relay part #775 and a (-)Negative thru a 110 Ohm Resistor, See DIAGRAM NOTE #3: the DOOR LOCKS on this vehicle require a (+)Positive thru a 2700 Ohm resistor to Lock and a (+)Positive thru a 620 Ohm resistor to Unlock, some units will also require extra relays for the keyless entry feature See DIAGRAMS. NOTE #4; The BCM (Body Control Module) is located under the left side of the dash, along side the JUNCTION BLOCK. NOTE #5: This vehicle uses a Multi-Coil Ignition system, at the Coil use any wire that has a TAN STRIPE for the TACH wire. NOTE #6: the DISARM wire on this vehicle requires a (+)Positive thru an extra Relay Part #775 and a 680 Ohm resistor, See DIAGRAM NOTE #7: this vehicle has 2 Door Trigger wires, when connecting to an ALARM SYSTEM, use both and DIODE ISOLATE, See DIAGRAM.

LINK 1	LINK TEXT 1	LINK 2	LINK TEXT 2

EXTRA INFORMATION

Show Large Image This picture shows the CHR-4 T-HARNESS Plugged into the Under Dash Side of the FACTORY IGNITION SWITCH Harness from the vehicle. Show Large Image This picture show the Side Dash Panel and Lower Dash panel that must be removed to gain access to the under dash wiring on this vehicle. Show Large Image to gain access to the IGNITION SWITCH HARNESS Plug you will need to remove the Tilt Wheel Lever and the Lower Steering Column Cover. Show Large Image The Tilt Wheel Lever is held in place by a screw that can be removed from the back of this lever. Show Large Image To remove the Under Dash Panel you will first need to remove this side panel and then remove the (2) screws that hold the edge of the under dash panel in place. Show Large Image The IGNITION SWITCH HARNESS is seen in this picture plugged into the Ignition Switch Harness Plug on the LOWER LEFTHAND SIDE of the Steering Column. The Steering Columns Lower cover must be removed to gain access to the Ignition Switch Harness and Plug. Show Large Image In this picture the FACTORY IGNITION SWITCH HARNESS is UNPLUGGED from the Ignition Switch on the Steering Column. This Harness needs only to be Unplugged if you are Installing a CHR-4 T-HARNESS when installing a Remote Starter. Show Large Image This picture shows the CHR-4 T-HARNESS installed between the Factory Ignition Switch Harness and the Ignition Switch of this vehicle. Show Large Image The BLACK/WHITE (+) TRUNK RELEASE wire is located at the Truck Release Switch on the back of the Under Dash Panel and is marked with a RED Clip in this picture. Show Large Image The WHITE/TAN (+) BRAKE wire is located at the Brake Switch above the Brake Pedal in this vehicle, the Brake wire is marked with the RED Clip in this picture.