PRINT
CHRYSLER CROSSFIRE
MODEL YEAR(S
CROSSFIRE 2008
KEY T-HARNESS IMMOBILIZER
N/A N/A CHRYSLER'S TRANSPONDER ANTI-THEFT SYSTEM, See NOTE #1
PART COLOR LOCATION DIAGRAM
12 VOLT CONSTANT RED (+) @ IGNITION SWITCH, (7-Pin Plug) Pin 5
STARTER PURPLE (+) @ IGNITION SWITCH, (7-Pin Plug) Pin 4
STARTER 2 N/A
IGNITION 1 PINK/RED (+) @ IGNITION SWITCH, (7-Pin Plug) Pin 1
IGNITION 2 PINK/YELLOW (+) @ IGNITION SWITCH, (7-Pin Plug) Pin 3
IGNITION 3 N/A
ACCESSORY/HEATER BLOWER 1 PINK/DK. GREEN (+) @ IGNITION SWITCH, (7-Pin Plug) Pin 6
ACCESSORY/HEATER BLOWER 2 DK. GREEN/WHITE (+) @ IGNITION SWITCH, (7-Pin Plug) Pin 2
KEYSENSE N/A
PARKING LIGHTS ( - ) N/A
PARKING LIGHTS ( + ) GRAY/BLACK(+)(Left) and GRAY/RED(+)(Right) Use both. @ ICM, (BLACK, 21-Pin Plug) Pins 19 and 7, Note #2
POWER LOCK WHITE/DK. GREEN (-) thru a 180 Ohm Resistor, Note #4 @ CENTRAL LOCKING Switch on Dash, Pin 8
POWER UNLOCK Use LOCK wire (-)
LOCK MOTOR WIRE N/A
DOOR TRIGGER BROWN/GRAY (-) @ SSM, (18-Pin Plug(C1) Pin 14, Note #3
DOMELIGHT SUPERVISION BLUE/BROWN (-) @ DOME LIGHT
TRUNK RELEASE N/A
SLIDING POWER DOOR N/A
HORN BLACK/PINK (-) @ HORNS or RELAY CONTROL MODULE, Note #5
TACH Any wire NOT BLACK/DK. GREEN or BLACK/YELLOW (AC) @ Any IGNITION COIL
WAIT TO START LIGHT N/A
BRAKE BLACK/RED (+) @ ICM, (WHITE, 21-Pin Plug) Pin 2, Note #2
FACTORY ALARM DISARM BLACK (-) in DRIVERS KICK PANEL or SKREM (18-Pin Plug) Pin 8, Note #6
ANTI-THEFT CHRYSLER'S TRANSPONDER ANTI-THEFT SYSTEM, See NOTE #1
NOTES
Note #1: CHRYSLER'S ANTI-THEFT TRANSPONDER System, Requires INTERFACE BYPASS

MODULE, PART #CHALL and CHTH2 Module for Remote Starting and Door Locks with

no resistors or extra parts needed. To order go to the INTERFACE BYPASS MODULE

Page on this website.





Note #2: the ICM (Illumination control Module) is part of the Headlight Switch.







Note #3: the SSM (Security System Module) is part of the Central Locking Pump on the Right

Rear Floor fo the Luggage Compartment.







Note #4: the POWER LOCK/UNLOCK wire will only work when the vehicle is running, the Factory

Alarm Arm/Disarm wires only work when the vehicle is not running. You will need to use

both sets for the Locks to work with Remote Start and Ignition Locks.







Note #5: the RELAY CONTROL MODULE is located in the Control Module Box, next to the Battery,

in the Engine Compartment.







Note #6: the SKREM (Sentry Key Remote Entry Module) is located behind the

Instrument Cluster.
LINK 1 LINK TEXT 1 LINK 2 LINK TEXT 2