NOTE #1: TOYOTA'S TRANSPONDER SYSTEM, Requires Bypass Module:
(For Remote Starting Only) Part #791 Bypass, (Requires Extra Key) for Operation.
(For Remote Starting Only) Part # PK-ALL Bypass. (No Extra Key Required for
Operation) 2-KEYS Required to Program Module.
To order please go to the SECURITY BYPASS MODULE Page or INTERFACE BYPASS
MODULE Page on this website.
NOTE #2: the BECU (Body Electronic Control Unit) is located behind the GLOVE BOX, and is
the Module to the RIGHT.
NOTE #3: THIS VEHICLE REQUIRES A SPECIAL DOOR LOCK DIAGRAM THAT REQUIRES AN
EXTRA RELAY PART #775 AND A 1 AMP DIODE, TO CONNECT, See DIAGRAM,
The DRIVERS side LOCK/UNLOCK wires are at the DRIVERS DOOR MODULE in the
DRIVERS DOOR, they are: LOCK is a GREEN, Pin 4, UNLOCK is a YELLOW, Pin 14
and LOCK DETECTION ia s BROWN, Pin 16. The PASSENGER side LOCK/UNLOCK
wires are at the BECU, 2ND Plug down from the top: the LOCK is a PURPLE, Pin 8,
the UNLOCK is a LIGHT BLUE, Pin 13 and the LOCK DETECTION is a BROWN, Pin 11
NOTE #4: the DRIVERS DOOR TRIGGER is a BLACK (-) 3RD Plug down, Pin 11, the PASSENGER
DOOR TRIGGER is a LIGHT BLUE (-) Bottom Plug, Pin 16, the DRIVERS REAR DOOR
TRIGGER is a GREEN (-) TOP Plug, Pin 15, and the PASSENGER REAR DOOR
TRIGGER is a GREEN (-) Bottom Plug, Pin 15, When connecting to an Alarm System,
use all 4 wires and DIODE ISOLATE, See DIAGRAM
NOTE #5: the DOME LIGHT SUPERVISION wire is also a BROWN (-) at the BECU, Bottom Plug,
Pin 11
|