PRINT
CHRYSLER PT CRUISER
MODEL YEAR(S
PT CRUISER 2009-2010
KEY T-HARNESS IMMOBILIZER
CHRKEY-4 N/A CHRYSLER'S MULTIPLEX IGNITION/ANTI-THEFT SYSTEM, See Note #1
PART COLOR LOCATION DIAGRAM
12 VOLT CONSTANT RED (+) @ BATTERY
STARTER PINK/LT.BLUE (+) @ IGNITION Switch, (BLACK, 5-Pin Plug) Pin 4
STARTER 2 PURPLE/BROWN (-) thru a 180 Ohm Resistor, See NOTE #1 @ IGNITION Switch, (BLACK, 5-Pin Plug) Pin 2 NewFiles_PT-CRUISER_26500_PT-CRUISER_CHRYSLERS STARTER 2 AND ACCESSORY DIAGRAM.pdf
IGNITION 1 PINK/WHITE (+) @ IGNITION Switch, (BLACK, 5-Pin Plug) Pin 3
IGNITION 2 N/A
IGNITION 3 N/A
ACCESSORY/HEATER BLOWER 1 Use STARTER 2 wire, (-) thru a 610 Ohm Resistor, See NOTE #1
ACCESSORY/HEATER BLOWER 2 N/A
KEYSENSE N/A
PARKING LIGHTS ( - ) N/A
PARKING LIGHTS ( + ) WHITE/PURPLE (+) in DRIVERS KICK PANEL, Harness to Rear of Vehicle.
POWER LOCK LT. GREEN/DK. GREEN (-) thru a 1000 Ohm Resistor, SEE NOTE #2 in DRIVERS KICK PANEL or INSTRUMENT CLUSTER, (BROWN, 20-Pin Plug) Pin 18 NewFiles_PT-CRUISER_14301_PT-CRUISER_CHRYSLER PT CRUISER II 1 WIRE JBS UNITS.pdf
POWER UNLOCK Use LOCK wire, (-) thru a 249 Ohm Resistor, SEE NOTE #2 NewFiles_PT-CRUISER_14301_PT-CRUISER_CHRYSLER PT CRUISER II 1 WIRE ALERT SHE~FEB.pdf
LOCK MOTOR WIRE TAN/DK. BLUE (5-wire type) in DRIVERS KICK PANEL or INSTRUMENT CLUSTER, (BLACK, 10-Pin Plug) Pin 9
DOOR TRIGGER TAN to PURPLE(-) (Wagon), PURPLE (-) (Convertible), SEE NOTE #3 n DRIVERS KICK PANEL or INSTRUMENT CLUSTER, (BROWN, 20-Pin Plug) Pin 3 NewFiles_PT-CRUISER_2082_PT-CRUISER_(-) NEGATIVE DOOR PIN ISOLATION CIRCUIT.pdf
DOMELIGHT SUPERVISION YELLOW/WHITE (+) in DRIVERS KICK PANEL or INSTRUMENT CLUSTER, (BROWN, 20-Pin Plug) Pin 4
TRUNK RELEASE TAN/DK. GREEN(-) (Wagon), TAN/LT. GREEN (-) (Convertible), SEE NOTE #4 in DRIVERS KICK PANEL or INSTRUMENT CLUSTER, (BLACK, 20-Pin Plug) Pin 13
SLIDING POWER DOOR N/A
HORN DK. GREEN/PURPLE (-) @HORN Switch or INSTRUMENT CLUSTER, (BLACK, 20-Pin Plug) Pin 10
TACH Any wire NOT DK. GREEN/ORANGE (AC) @ Any FUEL INJECTOR
WAIT TO START LIGHT N/A
BRAKE DK. GREEN/WHITE (+) @ BRAKE SWITCH or INSTRUMENT CLUSTER, (BROWN, 20-Pin Plug) Pin 8
FACTORY ALARM DISARM DISARMS with FACTORY REMOTE ONLY!!
ANTI-THEFT CHRYSLER'S MULTIPLEX IGNITION/ANTI-THEFT SYSTEM, See Note #1
NOTES
Note #1: CHRYSLER'S MULTIPLEX IGNITION/ANTI-THEFT SYSTEM, Requires INTERFACE BYPASS

MODULE Part # DB-ALL or XK09 that will BYPASS the ANTI-THEFT SYSTEM and BYPASS

the need for the above resistors and relays, it will also bypass the need for the

resistors on the door locks, to order please go to the INTERFACE BYPASS MODULE

page on this website







NOTE #2: This vehicle uses a 1-Wire Door Locking System, the LOCK requires a (-) Negative

thru a 1000 Ohm Resistor and the UNLOCK requires a (-) Negative thru a 250 Ohm

resistor, depending on the unit some will also require (2) 775 relays See DIAGRAMS.

also See NOTE #1





NOTE #3: The DRIVERS DOOR is a TAN (-) to PURPLE (-) in Pin 3, the PASSENGER DOOR is a

TAN/RED (-) to PURPLE/WHITE (-) in Pin 11. The DRIVERS REAR DOOR is a

TAN/ORANGE (-) to PURPLE/GRAY (-) in Pin 5. The PASSENGER REAR DOOR is a

TAN/YELLOW (-) to PURPLE/YELLOW (-) in Pin 6. When connecting to an ALARM

SYSTEM use all 4 wires and DIODE ISOLATE See DIAGRAM







NOTE #4: On CONVERTIBLE's the TRUNK RELEASE is at the Switch in the Glove box, on Wagon's

test this wire while opening the hatch from the handle on the rear hatch, the

TRUNK/HATCH Release Motor wire is a TAN/YELLOW (+) in the Drivers Kick Panel.
LINK 1 LINK TEXT 1 LINK 2 LINK TEXT 2