PRINT
TOYOTA FJ CRUISER
MODEL YEAR(S
FJ CRUISER 2007-2014
KEY T-HARNESS IMMOBILIZER
TOYKEY-2 N/A TOYOTA'S TRANSPONDER SYSTEM, See NOTE #1
PART COLOR LOCATION DIAGRAM
12 VOLT CONSTANT BLUE/BLACK (+) @ IGNITION SWITCH, (WHITE, 8-Pin Plug) Pin 7
STARTER GREEN/BLACK (+) @ IGNITION SWITCH, (WHITE, 8-Pin Plug) Pin 8
STARTER 2 BLACK/WHITE (+) @ IGNITION SWITCH, (WHITE, 8-Pin Plug) Pin 1
IGNITION 1 BLACK/RED (+) @ IGNITION SWITCH, (WHITE, 8-Pin Plug) Pin 6
IGNITION 2 BLUE/YELLOW (+) @ IGNITION SWITCH, (WHITE, 8-Pin Plug) Pin 4
IGNITION 3 N/A
ACCESSORY/HEATER BLOWER 1 WHITE/GREEN (+) @ IGNITION SWITCH, (WHITE, 8-Pin Plug) Pin 3
ACCESSORY/HEATER BLOWER 2 N/A
KEYSENSE N/A
PARKING LIGHTS ( - ) GREEN (-) @ HEADLIGHT Switch or BECU, (TOP, WHITE, 26-Pin Plug) Pin 8, NOTE #2
PARKING LIGHTS ( + ) GREEN (+) @ DASH FUSE BOX, (WHITE, 16-Pin Plug(F) Pin 13
POWER LOCK GREEN/BLACK (-) TYPE B, NOTE #3 @ DRIVERS KICK PANEL, (WHITE, 18-Pin Plug), Pin 4
POWER UNLOCK GREEN/WHITE to BLUE/ORANGE (-) TYPE B, NOTE #4 @ DRIVERS KICK PANEL, (WHITE, 18-Pin Plug), Pin 5
LOCK MOTOR WIRE BLACK/WHITE to BLUE/RED (5-wire type) @ DRIVERS KICK PANEL, (WHITE, 13-Pin Plug), Pin 8
DOOR TRIGGER PURPLE/YELLOW (-) @ BODY ECU, (TOP, WHITE, 26-Pin Plug) Pin 12, NOTE #5
DOMELIGHT SUPERVISION WHITE (-) @ DASH FUSE BOX, (WHITE, 20-Pin Plug(A) Pin 8
TRUNK RELEASE BLUE/YELLOW (5-WIRE) #775 Relay Required @ MOTOR IN REAR DOOR
SLIDING POWER DOOR N/A
HORN GREEN/RED (-) @ HORN Switch (BLACK, 12-Pin Plug) Pin 6
TACH BLACK/WHITE (AC) @ DATA Link Connector, (WHITE, 16-Pin Plug) Pin 9
WAIT TO START LIGHT N/A
BRAKE GREEN/YELLOW (+) @ BRAKE SWITCH or DASH FUSE BOX, (WHITE, 16-Pin Plug(F), Pin 16
FACTORY ALARM DISARM PINK (-) (Requires Double Pulse) NOTE #6 @ DRIVERS KICK PANEL, (WHITE, 18-Pin Plug), Pin 8
ANTI-THEFT TOYOTA'S TRANSPONDER ANTI-THEFT SYSTEM @ IGNITION SWITCH TUMBLER
NOTES
NOTE #1: TOYOTA'S TRANSPONDER SYSTEM, Requires Bypass Module:

(For Remote Starting Only) Part #791 Bypass, (Requires Extra Key) for Operation.



(For Remote Starting Only) Part # PK-ALL Bypass. (No Extra Key Required for

Operation) To order CALL Tech Support at 800 561 1110 ex. 2146, NOTE #2: the BECU (Body Electronic Control Unit) is connected to the back of the FUSE BOX

under the DRIVERS SIDE of the DASH. This Unit has (3) Harness connectors on the

RIGHT Side of the FUSE BOX.





NOTE #3: this wire is only needed if the Door Locks do not function with the Aftermarket System

while the vehicle is running. All other times just use the Factory Alarm Arm wire.







NOTE #4: this wire is only needed if the Door Locks do not function with the Aftermarket System

while the vehicle is running. All other times just use the Factory Alarm Disarm wire.







NOTE #5: the BODY ECU is attached to the Back of the DASH FUSE BOX, it has 3 Plugs on the

Right side Edge.





NOTE #6: TEST this wire while turning the Key in the Drivers Door. This wire will also Unlock the

Doors





LINK 1 LINK TEXT 1 LINK 2 LINK TEXT 2