PRINT
INFINITI FX45
MODEL YEAR(S
FX45 2006-2008
KEY T-HARNESS IMMOBILIZER
N/A N/A INFINITI'S TRANSPONDER ANTI-THEFT SYSTEM, Requires Bypass Module, See NOTE #1
PART COLOR LOCATION DIAGRAM
12 VOLT CONSTANT BLUE/RED to RED (+) WHITE 6-PIN PLUG, PIN 1 @ IGNITION SWITCH
STARTER BLUE (+) USE BOTH WIRES WHITE 6-PIN PLUG, PIN 5 @ IGNITION SWITCH
STARTER 2 PINK (+) FOR REMOTE STARTING!! WHITE 6-PIN PLUG, PIN 6 @ IGNITION SWITCH
IGNITION 1 BLACK (+) WHITE 6-PIN PLUG, PIN 3 @ IGNITION SWITCH
IGNITION 2 N/A
IGNITION 3 N/A
ACCESSORY/HEATER BLOWER 1 WHITE (+) WHITE 6-PIN PLUG, PIN 2 @ IGNITION SWITCH
ACCESSORY/HEATER BLOWER 2 N/A
KEYSENSE BLACK/WHITE (+) Required! @ IGNITION SWITCH
PARKING LIGHTS ( - ) N/A
PARKING LIGHTS ( + ) RED to WHITE (+) WHITE 12-PIN PLUG, PIN 2, in DRIVERS KICK
POWER LOCK PINK (TYPE B), See NOTE #3 WHITE 16-PIN PLUG, PIN 4 @ POWER WINDOW MAIN SWITCH
POWER UNLOCK ORANGE (TYPE B), Requires Double Pulse, See NOTE #4 WHITE 16-PIN PLUG, PIN 6 @ POWER WINDOW MAIN SWITCH
LOCK MOTOR WIRE PURPLE (5-WIRE TYPE) BLACK 15-PIN PLUG, PIN 10 @ BCM, See NOTE #2
DOOR TRIGGER WHITE (-) WHITE 15-PIN PLUG, PIN 7 @ BCM, See NOTE #2
DOMELIGHT SUPERVISION PURPLE/WHITE (-) BLACK 15-PIN PLUG, PIN 8 @ BCM, See NOTE #2
TRUNK RELEASE YELLOW (-), See NOTE #5 @ BACK DOOR OPENER, SWITCH in HATCH
SLIDING POWER DOOR N/A
HORN GREEN/BLACK to LT.BLUE (-) @ HORN SWITCH in Column
TACH Any wire NOT RED (AC) @ Any FUEL-INJECTOR
WAIT TO START LIGHT N/A
BRAKE PINK (+) @ BRAKE PEDAL SWITCH
FACTORY ALARM DISARM N/A
ANTI-THEFT INFINITI'S TRANSPONDER ANTI-THEFT SYSTEM, Requires Bypass Module, See NOTE #1
NOTES
NOTE #1 This vehicle is Equipped with a TRANPONDER ANTI-THEFT System that will requires a Bypass Module for REMOTE STARTING:



Part # 791 Bypass Module will work IF you have another IGNITION key that you can give up, this key will need to be placed inside the 791 Bypass Module and be left there for Remote Starting.





Part # DB-ALL or XK09 is a Keyless Bypass Module used for Remote Starting that DOES NOT require a Key to be left inside the bypass module. To order go to the INTERFACE BYPASS MODULE PAGE on this website.





NOTE #2: the BCM (Body Control Module) is located in the DRIVERS KICK PANEL.







NOTE #3: TEST this wire while Turning the KEY in the Drivers Door. This wire will also ARM the

FACTORY ALARM.







NOTE #4: TEST this wire while Turning the KEY in the Drivers Door. This wire will also DISARM the

FACTORY ALARM.







NOTE #5: TEST this wire while opening the HATCH with the Handle on the REAR of the Vehicle.

On vehicles with INTELLIGENT KEY, it is a LT. GREEN (-) located in the DRIVERS KICK

PANEL, Harness to REAR of Vehicle.
LINK 1 LINK TEXT 1 LINK 2 LINK TEXT 2