|
PART
|
COLOR
|
LOCATION
|
DIAGRAM
|
|
12 VOLT CONSTANT
|
RED (+)
|
@ BCM, C1 PIN 37 and 34, See NOTE #1
|
|
|
STARTER
|
SEE NOTE #4
|
|
|
|
STARTER 2
|
N/A
|
|
|
|
IGNITION 1
|
DARK BLUE (+)
|
IGNITION SWITCH HARNESS
|
|
|
IGNITION 2
|
N/A
|
|
|
|
IGNITION 3
|
N/A
|
|
|
|
ACCESSORY/HEATER BLOWER 1
|
BROWN (+)
|
IGNITION SWITCH HARNESS
|
|
|
ACCESSORY/HEATER BLOWER 2
|
N/A
|
|
|
|
KEYSENSE
|
N/A
|
|
|
|
PARKING LIGHTS ( - )
|
N/A
|
|
|
|
PARKING LIGHTS ( + )
|
BROWN (+)
|
@ HEADLIGHT SWITCH
|
|
|
POWER LOCK
|
WHITE (1-Wire System) See NOTE #2
|
@ BCM C3, PIN 33, See DIAGRAMS
|
14301_ION_ION 1 WIRE JBS UNITS.pdf
|
|
POWER UNLOCK
|
Same wire, See DIAGRAM
|
See DIAGRAMS
|
14301_ION_ION 1 WIRE ALERT SHELBY UNITS.pdf
|
|
LOCK MOTOR WIRE
|
GRAY (5-WIRE TYPE)
|
@ BCM, C3, Pin 51, See NOTE #1
|
|
|
DOOR TRIGGER
|
SEE NOTE #3
|
@ BCM, See NOTE #1
|
26500_ION_(-) NEGATIVE DOOR PIN ISOLATION CIRCUIT.pdf
|
|
DOMELIGHT SUPERVISION
|
WHITE (-)
|
@ BCM C3, IN PIN 11, See NOTE #1
|
|
|
TRUNK RELEASE
|
BLACK/WHITE (+)
|
@ BCM C3, IN PIN 1, See NOTE #1
|
|
|
SLIDING POWER DOOR
|
N/A
|
|
|
|
HORN
|
BLACK (-)
|
@ STEERING COLUMN HARNESS
|
|
|
TACH
|
WHITE or ORANGE (AC)
|
IN PIN B or G @ MODULE, TOP LEFT OF ENGINE
|
|
|
WAIT TO START LIGHT
|
N/A
|
|
|
|
BRAKE
|
LIGHT BLUE (+)
|
@ SWITCH ABOVE BRAKE PEDAL
|
|
|
FACTORY ALARM DISARM
|
N/A
|
|
|
|
ANTI-THEFT
|
SATURN'S MULTIPLEX IGNITION/TRANSPONDER SYSTEM, See NOTE #4
|
|
|
|
NOTES
|
NOTE #1: THE BCM (Body Control Module) IS PART OF THE FUSE/RELAY BOX IN THE LOWER CENTER OF THE DASH,JUST BELOW THE HVAC CONTROL ASSEMBLY.IT HAS THE FOLLOWING CONNECTORS:C1-37 PIN BLACK PLUG,C2-38 PIN GRAY PLUG,C3-56 PIN BLACK PLUG,C4-56 PIN GRAY PLUG,AND C5-6 PIN GRAY PLUG.
NOTE #2 LOCK IS A STRAIGHT (-) NEGATIVE TRIGGER. UNLOCK IS A NEGATIVE THRU 1.5K OHM RESISTOR, IF THE UNIT DOES NOT HAVE ON BOARD DOOR LOCK RELAYS, EXTRA RELAYS PART #775,WILL BE REQUIRED, See DIAGRAMS.
NOTE #3 THE DRIVERS DOOR TRIGGER IS LIGHT GREEN/BLACK (-) IN PIN 45 AND THE PASSENGER DOOR(S) IS LIGHT BLUE (-) IN PIN 44. WHEN CONNECTING TO AN ALARM SYSTEM USE BOTH DOOR TRIGGER WIRES AND DIODE ISOLATE, TO CONNECT, SEE DIAGRAM.
NOTE #4: THIS VEHICLE REQUIRES AN INTERFACE BYPASS MODULE TO REMOTE START, PART # DBALL2 or XK09, Part # 779, ignition delay circuit is needed when installing an RS82, RS1100, or RS1200 and a DBALL2 or XK09 interface in a GM vehicle that has no starter/ crank wire coming from the ignition switch. TO ORDER PLEASE Call 800 561 1110 ex. 2146
|