|
PART
|
COLOR
|
LOCATION
|
DIAGRAM
|
|
12 VOLT CONSTANT
|
LIGHT BLUE/RED (+)
|
@ IGNITION SWITCH HARNESS
|
|
|
STARTER
|
PINK/DARK GREEN (+)
|
@ IGNITION SWITCH HARNESS
|
|
|
STARTER 2
|
PURPLE/BROWN (-), See NOTE #1
|
@ IGNITION SWITCH HARNESS
|
14301_MAGNUM_CHRYSLERS STARTER 2 AND ACCESSORY DIAGRAM.pdf
|
|
IGNITION 1
|
PINK/WHITE (+)
|
IGNITION SWITCH HARNESS
|
|
|
IGNITION 2
|
N/A
|
|
|
|
IGNITION 3
|
N/A
|
|
|
|
ACCESSORY/HEATER BLOWER 1
|
PURPLE/BROWN (-), See NOTE #1
|
IGNITION SWITCH HARNESS, See DIAGRAM
|
|
|
ACCESSORY/HEATER BLOWER 2
|
N/A
|
|
|
|
KEYSENSE
|
N/A
|
|
|
|
PARKING LIGHTS ( - )
|
WHITE/BROWN (-), See NOTE #5
|
@ HEADLIGHT SWITCH, See DIAGRAM
|
15941_MAGNUM_CHRYSLER PARKING LIGHT DIAGRAM.pdf
|
|
PARKING LIGHTS ( + )
|
WHITE/PURPLE (+)
|
IN PASSENGER KICK, BROWN 26 Pin Plug, Pin 26
|
|
|
POWER LOCK
|
PURPLE/DARK GREEN (1-Wire Door Lock System), See NOTE #2
|
IN DRIVERS KICK PANEL, See DAIGRAM
|
29241_MAGNUM_DODGE MAGNUM 1 WIRE JBS UNITS.pdf
|
|
POWER UNLOCK
|
Same wire, See DIAGRAM
|
See DIAGRAMS
|
6617_MAGNUM_DODGE MAGNUM 1 WIRE ALERT SHELBY UNITS.pdf
|
|
LOCK MOTOR WIRE
|
LIGHT GREEN (5-WIRE TYPE)
|
IN DRIVERS KICK PANEL
|
|
|
DOOR TRIGGER
|
See NOTE #3
|
IN EACH KICK PANEL
|
|
|
DOMELIGHT SUPERVISION
|
YELLOW/WHITE (-), (Requires #775 Relay)
|
IN PASSENGER A PILLAR
|
|
|
TRUNK RELEASE
|
PURPLE/TAN (-), See NOTE #4, (Requires #775 Relay)
|
IN PASSENGER KICK PANEL, See DIAGRAM
|
29241_MAGNUM_DODGE MAGNUM HATCH RELEASE DIAGRAM.pdf
|
|
SLIDING POWER DOOR
|
N/A
|
|
|
|
HORN
|
DARK GREEN/ORANGE (+)
|
@ HORNS under HOOD
|
|
|
TACH
|
ANY wire NOT BROWN/YELLOW (AC)
|
@ ANY COIL or FUEL INJECTOR
|
|
|
WAIT TO START LIGHT
|
N/A
|
|
|
|
BRAKE
|
DARK GREEN/WHITE (+)
|
@ SWITCH ABOVE BRAKE PEDAL
|
|
|
FACTORY ALARM DISARM
|
N/A
|
|
|
|
ANTI-THEFT
|
CHRYSLERS MULTIPLEX IGNITION/TRANSPONDER SYSTEM, See NOTE #1
|
@ IGNITION SWITCH TUMBLER
|
|
|
NOTES
|
Note #1: CHRYSLER'S MUX/TRANSPONDER IGNITION , Requires a INTERFACE BYPASS MODULE for
REMOTE STARTING and KELESS ENTRY, Part # DB-ALL or XK09 either Module will work,
to order go to the INTERFACE BYPASS MODULE Page on this website.
NOTE #2: this vehicle uses a 1-Wire Door Locking System, LOCK requires a (-)Negative thru a
330 Ohm Resistor and UNLOCK requires a (-)Negative thru a 100 Ohm Resistor,
some units will also require 2 extra relays, to connect, See DIAGRAM
NOTE #3: the DRIVERS DOOR is a PURPLE (-) wire in the WHITE plug Pin 3, the PASSENGER
DOOE is a PURPLE/WHITE (-) in the WHITE plug Pin 3. the DRIVERS REAR DOOR is a
PURPLE/GRAY (-) in the GRAY 26 Pin plug, Pin 10 and the PASSENGER REAR DOOR is
a PURPLE/YELLOW (-) in the GRAY 26 Pin plug, Pin 9. When connecting to an ALARM
SYSTEM, use all 4 DOOR TRIGGER wires and DIODE ISOLATE, to connect,
See DIAGRAM
NOTE #4: the REAR HATCH RELEASE will require a (-)Negative thru a 4700 Ohm Resistor and a
extra Relay Part #775, to connect, See DIAGRAM
NOTE #5: to turn on the parking Lights on this vehicle will require a (-) Negative thru a 1670
Ohm and may also require a #775 Relay, to connect See DIAGRAM
|