PRINT
FORD FUSION
MODEL YEAR(S
FUSION 2006
KEY T-HARNESS IMMOBILIZER
FDKEY-4 N/A FORD'S ANTI-THEFT TRANSPONDER SYSTEM, SEE NOTE #1
PART COLOR LOCATION DIAGRAM
12 VOLT CONSTANT BROWN/RED (+) @ IGNITION SWITCH HARNESS
STARTER BLUE/WHITE (+) @ IGNITION SWITCH HARNESS
STARTER 2 N/A
IGNITION 1 WHITE/ORANGE (+) @ IGNITION SWITCH HARNESS
IGNITION 2 N/A
IGNITION 3 N/A
ACCESSORY/HEATER BLOWER 1 PURPLE/GREEN (+) @ IGNITION SWITCH HARNESS
ACCESSORY/HEATER BLOWER 2 N/A
KEYSENSE N/A
PARKING LIGHTS ( - ) N/A
PARKING LIGHTS ( + ) GRAY/YELLOW (+) IN DRIVERS KICK PANEL or SJB, Connector E, Pin 30, See NOTE #2
POWER LOCK GRAY/YELLOW (TYPE B) IN DRIVER KICK PANEL or SJB, Connector C, Pin 4, See NOTE #2 and NOTE #3
POWER UNLOCK PURPLE/GRAY (TYPE B) IN DRIVERS KICK PANEL or SJB, Connector C, Pin 10, See NOTE #2 and NOTE #3
LOCK MOTOR WIRE GRAY/BROWN (+) IN DRIVERS KICK PANEL
DOOR TRIGGER Use DOME LIGHT SUPERVISION wire
DOMELIGHT SUPERVISION BLUE (+) IN DRIVERS KICK PANEL or SJB, Connector E, Pin 16, See NOTE #2 and NOTE #4
TRUNK RELEASE BROWN (-), (Requires Part #775 Relay) @ TRUNK RELEASE SWITCH or SJB, Connector D, Pin 27, See NOTE #2
SLIDING POWER DOOR N/A
HORN BLUE/WHITE (-) @ HORN SWITCH or SJB, Connector B, Pin 6, See NOTE #2
TACH Any wire NOT GRAY or WHITE/BLUE (AC) @ Any FUEL-INJECTOR or IGNITION COIL
WAIT TO START LIGHT N/A
BRAKE PURPLE/WHITE (+) @ SWITCH above BRAKE PEDAL or SJB, Connector A, Pin 19, See NOTE #2
FACTORY ALARM DISARM PURPLE/BROWN (-) IN DRIVERS KICK PANEL or SJB, Connector C, Pin 5, See NOTE #2 and NOTE #5
ANTI-THEFT FORD'S TRANSPONDER SYSTEM, SEE NOTE #1 @ IGNITION SWITCH TUMBLER
NOTES
NOTE #1: This vehicle MAY BE equipped with a Special Anti-theft key, to remote start you will

need a Bypass module 791,(use this module IF you have a extra ignition key to

place inside the 791 to remote start, if you do not have an extra key to use or wish

not to have a key placed inside this bypass module, we OFFER a KEYLESS INTERFACE

BYPASS MODULE that does not require a key to be placed inside the bypass module,

this is Part # PKALL or PKFM, either one will work, to order, go to the INTERFACE

BYPASS MODULE PAGE on this website.





NOTE #2: the SJB (Smart Junction Box) is part of the FUSE/RELAY BOX under the DRIVERS

SIDE of the DASH.





NOTE #3: On Vehicles with MEMORY SEATS, the POWER LOCK and UNLOCK wires are in the

PASSENGER KICK PANEL or SJB (Smart Junction Box) and you will need to TEST these

wires while using the LOCK/UNLOCK Switch on the Passenger Door only.





NOTE #4: the DOMELIGHT SUPERVISION wire BLUE (+) can also be located in the PASSENGER

side "A" Pillar.





NOTE #5: Test this wire will turning the Key in the Drivers Door Key Cylinder.
LINK 1 LINK TEXT 1 LINK 2 LINK TEXT 2