|
PART
|
COLOR
|
LOCATION
|
DIAGRAM
|
|
12 VOLT CONSTANT
|
BLACK/RED (+), 50 AMP
|
@ VESCM, (2-PIN PLUG(I), PIN 1, NOTE #2
|
|
|
STARTER
|
RED/BLACK (+)
|
@ VESCM, (12-PIN PLUG(G), PIN 1, NOTE #2
|
|
|
STARTER 2
|
N/A
|
|
|
|
IGNITION 1
|
BLACK (+)
|
@ VESCM, (12-PIN PLUG(G), PIN 11, NOTE #2
|
|
|
IGNITION 2
|
N/A
|
|
|
|
IGNITION 3
|
N/A
|
|
|
|
ACCESSORY/HEATER BLOWER 1
|
N/A
|
|
|
|
ACCESSORY/HEATER BLOWER 2
|
N/A
|
|
|
|
KEYSENSE
|
N/A
|
|
|
|
PARKING LIGHTS ( - )
|
N/A
|
|
|
|
PARKING LIGHTS ( + )
|
GRAY/YELLOW (+), NOTE #6
|
@ VESCM, (16-PIN PLUG(E), PIN 1, NOTE #2
|
|
|
POWER LOCK
|
BROWN/GREEN (-) NOTE #3
|
@ DDCM, (32-PIN PLUG), PIN 32, NOTE #4
|
|
|
POWER UNLOCK
|
Use LOCK wire, (-) thru a 250 Ohm Resistor
|
|
|
|
LOCK MOTOR WIRE
|
YELLOW (+), 5-Wire Type
|
@ DDCM, (20-PIN PLUG), PIN 13, NOTE #4
|
|
|
DOOR TRIGGER
|
BROWN/YELLOW (-)
|
@ DDCM, (20-PIN PLUG), PIN 7, NOTE #4
|
|
|
DOMELIGHT SUPERVISION
|
RED/PURPLE (-)
|
@ VESCM, (12-PIN PLUG(B), PIN 11, NOTE #2
|
|
|
TRUNK RELEASE
|
PURPLE (-), NOTE #8
|
in DRIVERS KICK PANEL or CSCCM, (8-PIN PLUG), PIN 6, NOTE #5
|
|
|
SLIDING POWER DOOR
|
N/A
|
|
|
|
HORN
|
BLACK/WHITE (+)
|
@ VESCM, (6-PIN PLUG(J), PIN 6, NOTE #2
|
|
|
TACH
|
NOTE #9
|
@ Any FUEL-INJECTOR
|
|
|
WAIT TO START LIGHT
|
N/A
|
|
|
|
BRAKE
|
BLACK/RED (+), (TEST with IGNITION KEY ON)
|
@ VESCM, (16-PIN PLUG(E), PIN 2, NOTE #2
|
|
|
FACTORY ALARM DISARM
|
NOTE #7
|
@ DDCM, (20-PIN PLUG), PIN 16, NOTE #4
|
|
|
ANTI-THEFT
|
VW'S TRANSPONDER ANTI-THEFT SYSTEM, Requires Bypass Module, See NOTE #1
|
@ IGNITION SWITCH TUMBLER
|
|
|
NOTES
|
NOTE #1: VW'S TRANSPONDER ANTI-THEFT SYSTEM, Requires Bypass Module,
Part # 791 Bypass Module, for REMOTE STARTING ONLY!
Part # DLPK-CANBUS MULTI for REMOTE STARTING and DOOR LOCKS (Resistors for
DOOR LOCKS, NOT REQUIRED)
NOTE #2: the VESCM, (Vehicle Electrical System Control Module) is the RELAY BOX, Under
the DRIVERS DASH.
NOTE #3: this vehicle uses a 1-WIRE DOOR LOCKING SYSTEM, that Requires Extra Parts for
operation. See DIAGRAM. The use of Bypass Module DLPK-CANBUS MULTI will do the
ANTI-THEFT and DOOR LOCKS without the use of relays and resistors.
NOTE #4: the DDCM, (Drivers Door Control Module) is located in the DRIVERS DOOR.
NOTE #5: the CSCCM, ( Comfort System Central Control Module) is located behind the
GLOVE BOX.
NOTE #6: for the PARKING LIGHT FLASH option, it will be necessary to break the HEADLIGHT
Switch OFF wire, BLACK/YELLOW (+), located at the VESCM, (16-PIN PLUG(E), PIN 16.
NOTE #7: to DISARM FACTORY ALARM (if needed) Requires a (-) thru a 250 Ohm Resistor on
the GREEN/WHITE (-) wire, requires resistor and relay. TEST this wire while turning the
KEY in the DRIVERS DOOR.
NOTE #8: TEST this wire while Opening the TRUNK with the Handle on the REAR of the Vehicle
NOTE #9: when using the TACH wire, use a BROWN/BLACK, BROWN/WHITE, BROWN/PURPLE or
BROWN/GRAY, they all test (AC)
|