PRINT
MERCURY MILAN
MODEL YEAR(S
MILAN 2010-2011
KEY T-HARNESS IMMOBILIZER
FDKEY-6 N/A FORD'S TRANSPONDER ANTI-THEFT SYSTEM, See Note #1
PART COLOR LOCATION DIAGRAM
12 VOLT CONSTANT RED (+) @ SJB, (BLACK 1-Pin Plug(G) Pin 1, Note #2
STARTER BLUE/WHITE (+) @ IGNITION Switch, (7-Pin Plug) Pin 7
STARTER 2 N/A
IGNITION 1 WHITE/ORANGE (+) @ IGNITION Switch, (7-Pin Plug) Pin 1 or SJB, (BLACK 52-Pin Plug(B) Pin 45, Note #2
IGNITION 2 N/A
IGNITION 3 N/A
ACCESSORY/HEATER BLOWER 1 PURPLE/GREEN (+) @ IGNITION Switch, (7-Pin Plug) Pin 6 or SJB, (GRAY 14-Pin Plug(A) Pin 3, Note #2
ACCESSORY/HEATER BLOWER 2 N/A
KEYSENSE BLUE/GRAY (+) @ IGNITION Switch, (7-Pin Plug) Pin 5 or SJB, (BLACK 52-Pin Plug(B) Pin 35, Note #2
PARKING LIGHTS ( - ) N/A
PARKING LIGHTS ( + ) PURPLE/WHITE (+) in DRIVERS KICK PANEL or SJB, (BLACK 32-Pin Plug(D) Pin 20, Note #2
POWER LOCK BLUE/GREEN (TYPE B) in DRIVERS KICK PANEL or SJB, (GRAY 26-Pin Plug(C) Pin 17, Note #2
POWER UNLOCK YELLOW/PURPLE (TYPE B) in DRIVERS KICK PANEL or SJB, (GRAY 26-Pin Plug(C) Pin 4, Note #2
LOCK MOTOR WIRE GRAY/BROWN (+) in DRIVERS KICK PANEL or SJB, (BLACK 32-Pin Plug(D) Pin 6, Note #2
DOOR TRIGGER GREEN/PURPLE (-) N.C. @ SJB, (GRAY 26-Pin Plug(C) Pin 14, Note #2
DOMELIGHT SUPERVISION GRAY/PURPLE (+) in PASSENGER KICK PANEL or SJB, (GRAY 14-Pin Plug(A) Pin 9, Note #2
TRUNK RELEASE BROWN/YELLOW (-), (Requires #775 Relay) @ RELEASE SWITCH or SJB, (GRAY 26-Pin Plug(C) Pin 20, Note #2
SLIDING POWER DOOR N/A
HORN BLUE/WHITE (-) @ HORN SWITCH or SJB, (BLACK 52-Pin Plug(B) Pin 41, Note #2
TACH Any wire NOT BLUE (AC) @ ANY FUEL INJECTOR
WAIT TO START LIGHT N/A
BRAKE PURPLE/WHITE (+) @ BRAKE SWITCH or SJB, (BLACK 52-Pin Plug(B) Pin 40, Note #2
FACTORY ALARM DISARM DISARMS WITH FACTORY REMOTE ONLY!!
ANTI-THEFT FORD'S TRANSPONDER ANTI-THEFT SYSTEM, See Note #1 @ IGNITION SWITCH TUMBLER
NOTES
NOTE #1: This vehicle is equipped with a Special Anti-theft key, to remote start you will

need a Bypass module 791, use this module IF you have a extra ignition key to

place inside the 791 to remote start, if you do not have an extra key to use or wish

not to have a key placed inside this bypass module, we OFFER a KEYLESS INTERFACE

BYPASS MODULE that does not require a key to be placed inside the bypass module,

this is Part # PKALL or PKFM, either one will work, to order, go to the INTERFACE

BYPASS MODULE PAGE on this website.





Note #2: The SJB, (Smart Junction Box) is located under the Drivers Side of the Dash.
LINK 1 LINK TEXT 1 LINK 2 LINK TEXT 2