Show Large Image
This shows the TILT WHEEL LEVER on the Steering Column, to gain access to the IGNITION SWITCH HARNESS wires and the PASSLOCK 1 wires in the Steering Column the UPPER and LOWER STEERING COLUMN COVERS must be removed.
Show Large Image
This picture shows the TILT WHEEL LEVER removed, you will then need to remove the (3) 7mm bolts at the Bottom of the Lower Steering Column cover that will let you pull that cover off and then remove the upper cover.
Show Large Image
With both of the Steering Column Covers removed, you will see the IGNITION SWITCH Plug (BLACK) on the LEFT side of the column. In this IGNITION Plug, you will find a BLACK and a WHITE Plug that contain all of the IGNITION wires. In this picture you will s
Show Large Image
This picture shows both of the IGNITION SWITCH HARNESS Plugs removed from the back of the IGNITION SWITCH Plug. The (2) Plugs contain all of the necessary IGNITION wires. When adding a T-HARNESS or Installing a Remote Starter you will need to remove both
Show Large Image
"
Show Large Image
The BLACK IGNITION HARNESS Plug, contains both of the 12 Volt Constant wires and the BLACK BULB CHECK wires. The BLACK BULB Check wire is marked with the RED Clip in this picture.
Show Large Image
This picture shows the PASSLOCK 1 wires, the YELLOW (+) or will show 1 to 6 Volts DC on a Volt/Ohm Meter) BLACK (-) and WHITE (WHITE wire is NOT USED!!). These wires are shown as they leave the IGNITION SWITCH TUMBLER under the Steering Column of the vehi
Show Large Image
This is another view from a different angle that shows the PASSLOCK 1 wires, the YELLOW (+) or will show 1 to 6 Volts DC on a Volt/Ohm Meter) BLACK (-) and WHITE (WHITE wire is NOT USED!!). These wires are shown as they leave the IGNITION SWITCH TUMBLER u
Show Large Image
This picture shows the (+)WHITE BRAKE wire (marked with the RED Clip) as it exits the Brake Switch, next to the Brake Pedal, under the dash.
Show Large Image
This is a picture of the GM-8 T-HARNESS, if you purchased a T-Harness for this vehicle, use this picture to make sure you recieved the correct harness.
Show Large Image
This is a picture of the GM-8 T-HARNESS Male End of this T-Harness, if you purchased a T-Harness for this vehicle, use this picture to make sure you recieved the correct harness. The Male End of this T-Harness plugs into the Ignition Switch of the vehicle
Show Large Image
This is a picture of the GM-8 T-HARNESS Female End of this T-Harness, if you purchased a T-Harness for this vehicle, use this picture to make sure you recieved the correct harness. The Female End of this T-Harness plugs into the Ignition Switch Harness Pl
|