PRINT
DODGE CARAVAN
MODEL YEAR(S
CARAVAN 1996-2000
KEY T-HARNESS IMMOBILIZER
CHRKEY1 (1998-2000) N/A CHRYSLER'S ANTI-THEFT TRANSPONDER System (GRAY IGNITION KEY), See NOTE #1
PART COLOR LOCATION DIAGRAM
12 VOLT CONSTANT RED (+) @ IGNITION SWITCH HARNESS
STARTER YELLOW (+) @ IGNITION SWITCH HARNESS
STARTER 2 N/A
IGNITION 1 DARK BLUE (+) @ IGNITION SWITCH HARNESS
IGNITION 2 BLACK/WHITE (+) @ IGNITION SWITCH HARNESS
IGNITION 3 N/A
ACCESSORY/HEATER BLOWER 1 BLACK/ORANGE (+) @ IGNITION SWITCH HARNESS
ACCESSORY/HEATER BLOWER 2 N/A
KEYSENSE N/A
PARKING LIGHTS ( - ) GREEN/WHITE (-) or GREEN/RED (-), See NOTE #2 @ HEADLIGHT SWITCH, See DIAGRAM 9732_CARAVAN_CHRYSLER MINI VAN 96 - 00 NEGATIVE PARKING LIGHT DIAGRAM.pdf
PARKING LIGHTS ( + ) See NOTE #2 @ MARKER LIGHT wire, out under HOOD
POWER LOCK WHITE/DARK GREEN or WHITE/LIGHT GREEN (1-Wire Door Lock System) See NOTE #3 @ LEFT (WHITE) PLUG, at very BOTTOM of FUSEBOX/BCM, See NOTE #4 24464_CARAVAN_CHRYSLER MINI VAN 96 - 00 1 WIRE JBS UNITS.pdf
POWER UNLOCK Same wire, See DIAGRAM See DAIGRAM 9732_CARAVAN_CHRYSLER MINI VAN 96 - 00 1 WIRE ALERT SHELBY UNITS.pdf
LOCK MOTOR WIRE N/A
DOOR TRIGGER BROWN/LIGHT GREEN (-) @ DOMELIGHT ON/OFF SWITCH
DOMELIGHT SUPERVISION BROWN/WHITE (-), (Requires #775 Relay) @ DOMELIGHT ON/OFF SWITCH
TRUNK RELEASE N/A
SLIDING POWER DOOR N/A
HORN GRAY/ORANGE (-) @ TOP RIGHT PLUG of FUSEBOX
TACH GRAY or GRAY/RED (AC) @ COIL PACK
WAIT TO START LIGHT N/A
BRAKE WHITE/TAN (+) @ SWITCH ABOVE BRAKE PEDAL, GRAY Plug
FACTORY ALARM DISARM TO DISARM/ARM, See NOTE #4 See DIAGRAM 14301_CARAVAN_CHRYSLER MINI VAN 96 - 00 REARM CIRCUIT.pdf
ANTI-THEFT CHRYSLER'S ANTI-THEFT TRANSPONDER System (GRAY IGNITION KEY), See NOTE #1 @ IGNITION SWITCH TUMBLER
NOTES
NOTE #1: This vehicle may be equipped with CHRYSLER'S ANTI-THEFT TRANSPONDER System

(GRAY IGNITION KEY), if so to remote start will require the 791 BYPASS MODULE and

an extra Ignition key, to order go to the SECURITY BYPASS MODULE PAGE on this

website.







NOTE #2: The PARKING LIGHT wire is a GREEN/WHITE or a GREEN/RED on this vehicle and are

a (-)Negative type. These wires are located at the BACK of the HEADLIGHT Switch in

a BLACK Plug. To connect this wire will require an extra Relay part #775 to connect,

See DIAGRAM. You can also find a (+)Positive Parking Light wire at the PASSENGER

SIDE MARKER LIGHT in a BLACK harness out under the hood, open up this harness

and test for the correct PARKING LIGHT wire. You can see this HARNESS HEADING

into a LARGE HOLE in the FRONT PASSENGER FENDER in front of the WINDSHILED

WASHER BOTTLE, by making the connection there, you will not need to add the

extra relay.





NOTE #3: This vehicle uses a 1-Wire Door Locking System and will require extra parts. To

LOCK requires a (-)Negative thru a 1500, ARM requires a (-)Negative thru a 4020

Ohm Resistor and to UNLOCK requires a (-)Negative thru a 250 Ohm Resistor and

DISARM requires a (-)Negative thru a 665 Ohm Resistor. Some units will also

require 2 extra relays Part #775 to connect, See DIAGRAM





NOTE #4: the PLUG at the FUSEBOX/BCM that contains the POWER DOOR LOCK wire is the

(WHITE) LEFT plug, closest to the E-Brake Pedal. To remove this plug, pull the

carpeting out from under this plug (this will give you more room to remove this

plug) press on the WHITE release tab and wobble the plug from the bottom of the

FUSEBOX/BCM. At this time the POWER LOCKS will not function. Remove the

Electrical tape from the harness and seperate the WHITE/LIGHT GREEN and

WHITE/DARK GREEN wires from the rest of the wires in this plug, and plug this

harness back into the bottom of the FUSEBOX/BCM. The harness must be plugged

back into the BCM to test the LOCK/UNLOCK wire.







NOTE #5 you will need to UNLOCK THE VEHICLE, before Remote Starting to keep the Factory

Security from sounding See DIAGRAM





LINK 1 LINK TEXT 1 LINK 2 LINK TEXT 2
EXTRA INFORMATION