PRINT
INFINITI FX50
MODEL YEAR(S
FX50 2009-2011
KEY T-HARNESS IMMOBILIZER
N/A N/A INFINITI'S TRANSPONDER ANTI-THEFT SYSTEM, Requires Bypass Module, See NOTE #1
PART COLOR LOCATION DIAGRAM
12 VOLT CONSTANT WHITE (+) @ BCM, (BLACK, 3-PIN PLUG), PIN 1, NOTE #2
STARTER LT. BLUE (-) @ PUSH-BUTTON IGNITION Switch or BCM, (BLACK, 40-PIN PLUG), PIN 18, NOTE #2
STARTER 2 LT. GREEN (-) @ BCM, (GRAY, 40-PIN PLUG), PIN 21, NOTE #2
IGNITION 1 PINK (+) @ BCM, (BLACK, 40-PIN PLUG), PIN 11, NOTE #2
IGNITION 2 YELLOW (-) @ BCM, (GRAY, 40-PIN PLUG), PIN 16, NOTE #2
IGNITION 3 N/A
ACCESSORY/HEATER BLOWER 1 ORANGE (+) @ BCM, (BLACK, 40-PIN PLUG), PIN 31, NOTE #2
ACCESSORY/HEATER BLOWER 2 ORANGE (+) @ BCM, (BLACK, 40-PIN PLUG), PIN 24, NOTE #2
KEYSENSE N/A
PARKING LIGHTS ( - ) N/A
PARKING LIGHTS ( + ) RED (+) @ FUSE BOX, (WHITE, 10-PIN PLUG), PIN 8
POWER LOCK PURPLE (TYPE B), NOTE #3 @ POWER WINDOW Main Switch, (WHITE, 16-PIN PLUG), PIN 4
POWER UNLOCK YELLOW (TYPE B), Requires Double Pulse, NOTE #4 @ POWER WINDOW Main Switch, (WHITE, 16-PIN PLUG), PIN 6
LOCK MOTOR WIRE PURPLE (5-wire type) @ BCM, (WHITE, 16-PIN PLUG), PIN 5, NOTE #2
DOOR TRIGGER GRAY (-) @ BCM, (GREEN, 40-PIN PLUG), PIN 39, NOTE #2
DOMELIGHT SUPERVISION LT. BLUE (-) @ BCM, (WHITE, 16-PIN PLUG), PIN 16, NOTE #2
TRUNK RELEASE PINK (-) NOTE #5 @ BCM, (GRAY, 40-PIN PLUG), PIN 36, NOTE #2
SLIDING POWER DOOR N/A
HORN GREEN (-) @ HORN Switch, (GRAY, 8-PIN PLUG), PIN 8
TACH RED (AC) @ ECM, (GRAY, 32-PIN PLUG), PIN 14,(V6) or PIN 1(V8), NOTE #6
WAIT TO START LIGHT N/A
BRAKE PINK (+) @ BCM, (GREEN, 40-PIN PLUG), PIN 7, NOTE #2
FACTORY ALARM DISARM Use UNLOCK wire
ANTI-THEFT INFINITI'S TRANSPONDER ANTI-THEFT SYSTEM, Requires Bypass Module, See NOTE #1
NOTES
NOTE #1: NISSAN'S TRANSPONDER ANTI-THEFT SYSTEM, Requires Bypass Module,

Part # 791 or XK09 (For REMOTE START ONLY)

Part # DB-ALL (for REMOTE START and DOOR LOCKS)

To order go to the INTERFACE BYPASS MODULE Page on this websie.







NOTE #2: the BCM (Body Control Module) is located in the PASSENGER KICK PANEL.









NOTE #3: TEST this wire while Turning the KEY in the Drivers Door. This wire will also ARM the

FACTORY ALARM.





NOTE #4: TEST this wire while Turning the KEY in the Drivers Door. This wire will also DISARM the

FACTORY ALARM.





NOTE #5: TEST this wire while opening the LIFTGATE with the Handle on the REAR of the Vehicle.







NOTE #6; the ECM (Engine Control Module) is located behind the GLOVE BOX.
LINK 1 LINK TEXT 1 LINK 2 LINK TEXT 2