PRINT
LEXUS ES350
MODEL YEAR(S
ES350 2007-2008
KEY T-HARNESS IMMOBILIZER
N/A N/A TOYOTA'S TRANSPONDER SYSTEM, NOTE #1
PART COLOR LOCATION DIAGRAM
12 VOLT CONSTANT WHITE (+) @ FUSE BOX, (LEFT SIDE, 1-PIN PLUG)
STARTER BLUE (-) @ POWER SWITCH, (BLACK, 14-PIN PLUG) PIN 7 or BECU, (26-PIN PLUG) PIN 17, NOTE #5
STARTER 2 PURPLE (-) @ POWER SWITCH, (BLACK, 14-PIN PLUG) PIN 2 or BECU, (26-PIN PLUG) PIN 16, NOTE #5
IGNITION 1 ORANGE (+) @ BECU, (28-PIN PLUG) PIN 11, NOTE #5
IGNITION 2 LT. GREEN (+) @ BECU, (26-PIN PLUG) PIN 3, NOTE #5
IGNITION 3 N/A
ACCESSORY/HEATER BLOWER 1 RED (+) @ BECU, (26-PIN PLUG) PIN 22, NOTE #5
ACCESSORY/HEATER BLOWER 2 N/A
KEYSENSE N/A
PARKING LIGHTS ( - ) BLACK (-) @ BECU, (26-PIN PLUG) PIN 23, NOTE #5
PARKING LIGHTS ( + ) N/A
POWER LOCK RED (TYPE B), (TEST with PASSENGER Switch) NOTE #2 @ FUSE BOX, (TOP, RIGHT, 12-PIN PLUG) PIN 3
POWER UNLOCK GREEN (TYPE B), (TEST with PASSENGER Switch) NOTE #3 @ FUSE BOX, (TOP, RIGHT, 12-PIN PLUG) PIN 4
LOCK MOTOR WIRE BLUE (5-wire type) in DRIVERS KICK PANEL or FUSE BOX, (TOP, LEFT, 16-PIN PLUG) PIN 2
DOOR TRIGGER GRAY (-) @ BECU, (26-PIN PLUG) PIN 23, NOTE #5
DOMELIGHT SUPERVISION BROWN (-) @ FUSE BOX, (RIGHT SIDE, 12-PIN PLUG) PIN 5
TRUNK RELEASE PURPLE (-) @ RELEASE SWITCH or BECU, (26-PIN PLUG) PIN 26, NOTE #5
SLIDING POWER DOOR N/A
HORN GRAY to BLACK (-) @ HORN SWITCH or FUSE BOX, (MIDDLE, 16-PIN PLUG) PIN 11
TACH BLACK (AC) @ BECU, (16-PIN PLUG) PIN 8, NOTE #5
WAIT TO START LIGHT N/A
BRAKE WHITE (+) @ BRAKE SWITCH, above Brake Pedal or in DRIVERS KICK PANEL
FACTORY ALARM DISARM PURPLE (-) Requires Double Pulse, NOTE #4 in DRIVERS KICK PANEL or BECU, (26-PIN PLUG) PIN 10, NOTE #5
ANTI-THEFT TOYOTA'S TRANSPONDER SYSTEM, NOTE #1
NOTES
NOTE #1: LEXUS TRANSPONDER ANTI-THEFT SYSTEM, Requires Bypass Module,

Part # 791 Bypass Module (for REMOTE STARTING ONLY!) an Extra Ignition key is

required to be placed inside this module for Operation.



Part # PK-ALL Bypass Module (for REMOTE STARTING ONLY!) KEYLESS BYPASS

NO KEY is required for Operation.



Part # DB-ALL Bypass Module, this Module is a KEYLESS BYPASS MODULE and DOES

NOT require a Key to be placed inside the Module for Operation, this module will also

do the Keyless Entry.



To order the Bypass Module go to the INTERFACE BYPASS MODULE Page on this

website







NOTE #2: this wire is only needed if the Door Locks do not function with the Aftermarket System

while the vehicle is running. All other times just use the Factory Alarm Arm wire.



NOTE #3: this wire is only needed if the Door Locks do not function with the Aftermarket System

while the vehicle is running. All other times just use the Factory Alarm Disarm wire.





NOTE #4: TEST this wire while turning the Key in the Drivers Door, this wire will also Unlock

the Doors.



NOTE #5: the BECU, (Body Electronic Control Unit) is located under the Drivers Dash, attached

to the BACK of the DASH FUSE BOX.
LINK 1 LINK TEXT 1 LINK 2 LINK TEXT 2