PRINT
TOYOTA TACOMA
MODEL YEAR(S
TACOMA 2005-2008
KEY T-HARNESS IMMOBILIZER
TOYKEY-2 N/A TOYOTA'S TRANSPONDER ANTI-THEFT SYSTEM, See NOTE #1
PART COLOR LOCATION DIAGRAM
12 VOLT CONSTANT WHITE/BLUE (+) and WHITE/RED (+) @ IGNITION SWITCH HARNESS
STARTER GREEN/BLACK (+) See NOTE #2 @ IGNITION SWITCH HARNESS
STARTER 2 BLACK/WHITE (+) See NOTE #2 @ IGNITION SWITCH HARNESS
IGNITION 1 BLACK/RED (+) @ IGNITION SWITCH HARNESS
IGNITION 2 BLUE/YELLOW (+) @ IGNITION SWITCH HARNESS
IGNITION 3 N/A
ACCESSORY/HEATER BLOWER 1 WHITE/GREEN (+) @ IGNITION SWITCH HARNESS
ACCESSORY/HEATER BLOWER 2 N/A
KEYSENSE GREEN/BLACK (-) @ IGNITION SWITCH HARNESS
PARKING LIGHTS ( - ) GREEN (-) @ HEADLIGHT SWITCH or BCEU, PIN 13, See NOTE #3
PARKING LIGHTS ( + ) GREEN (+) @ FUSE BOX 13-Pin plug, Pin 10
POWER LOCK PURPLE (TYPE B), See NOTE #4 IN DRIVERS KICK PANEL, 10-Pin plug, Pin 4
POWER UNLOCK GREEN/BLACK (TYPE B) (Requires Double Pulse) IN DRIVERS KICK PANEL, 10-Pin plug, Pin 8
LOCK MOTOR WIRE BLUE/RED (5-WIRE TYPE) IN DRIVERS KICK PANEL, 12-PIN Plug, Pin 10
DOOR TRIGGER See NOTE #5 @ FUSEBOX 14301_TACOMA_(-) NEGATIVE DOOR PIN ISOLATION CIRCUIT.pdf
DOMELIGHT SUPERVISION BLUE (-), (Requires Part #775 Relay) @ FUSEBOX, BLACK 13-Pin plug, pin 9
TRUNK RELEASE N/A
SLIDING POWER DOOR N/A
HORN GREEN/RED (-) @ FUSEBOX, 18-PIN Plug, Pin 10
TACH BLACK/WHITE (AC) @ DATA LINK CONNECTOR,pin 9, See NOTE #6
WAIT TO START LIGHT N/A
BRAKE BLUE (+) @ FUSEBOX, 11-PIN Plug, Pin 2
FACTORY ALARM DISARM DISARMS with KEYSENSE wire, See NOTE #7 @ IGNITION SWITCH HARNESS
ANTI-THEFT TOYOTA'S TRANSPONDER ANTI-THEFT SYSTEM, See NOTE #1 @ IGNITION SWITCH TUMBLER
NOTES
NOTE #1: TOYOTA'S TRANSPONDER SYSTEM, Requires Bypass Module:

(For Remote Starting Only) Part #791 Bypass, (Requires Extra Key) for Operation.

(For Remote Starting Only) Part # PK-ALL Bypass. (No Extra Key Required for

Operation) 2-KEYS Required to Program Module.

To order please go to the SECURITY BYPASS MODULE Page or INTERFACE BYPASS

MODULE Page on this website.





NOTE #2; this vehicle uses (2) STARTER/CRANK wires, when connecting to a Remote Starter you

must connect BOTH STARTER/CRANK wires to the STARTER/CRANK wire from the

Remote Starter.





NOTE #3; the BECU (Body Electronic Control Unit) is attached to the back of the FUSE BOX,

with a single 26-Pin Plug.





NOTE #4: when testing the DOOR LOCK and UNLOCK wires, you must TEST these wires when

turning the kEY in the DRIVERS DOOR KEY CYLINDER ONLY.





NOTE #5; the DRIVERS DOOR is a GREEN/YELLOW (-) in the 18-pin plug, pin 7, the

PASSENGER DOOR is a RED/BLACK (-) in a 22-pin plug, pin 8, the REAR DOORS

are a PINK/BLACK (-) in an 18-pin plug pin 6, when connecting to an ALARM SYSTEM,

use all (3) DOOR TRIGGER wires and DIODE ISOLATE, to connect, See DIAGRAM





NOTE #6 the DATA LINK CONNECTOR is located under the DRIVERS SIDE of the DASH.





NOTE #7; THE KEYSENSE WIRE WILL DISARM THE VEHICLE WITHOUT UNLOCKING THE DOORS

BY APPLYING A (-)NEGATIVE TO THIS WIRE DURING REMOTE STARTING.







LINK 1 LINK TEXT 1 LINK 2 LINK TEXT 2