The (-) WHITE PARKING LIGHT wire, marked with the RED Clip in this picture is located in the Smaller of the (2) GRAY plugs on the BCM.
This is a picture of the GM-6 T-HARNESS, if you purchased a T-Harness for this vehicle, use this picture to make sure you recieved the correct harness.
This picture shows the WHITE,1-Wire Door LOCK/UNLOCK wire located in the BLACK Multi-Pin Plug, located in the Drivers Kick Panel.
By sliding the BCM out of it holder will let you gain access to the plugs on the unit a little better.
This picture shows the IGNITION SWITCH HARNESS wires in a cavity to the LEFT of the Radio with Radio removed, do not unplug the Radio, just let it hang outside of its mounting location. When NOT using a T-HARNESS, it is easier to catch these wire in this
This picture shows the PASSLOCK 2 wires, the YELLOW, BLACK and WHITE wires (WHITE wire is not used) seperated from the rest of the IGNITION SWITCH wires, in the IGNITION SWITCH Harness. The YELLOW and the BLACK wires are used when connecting the 791 Bypas
After removing the Brake Switch cover, you will be able to see the Brake Switch mounted to the Bracket above the Brake Pedal. The BRAKE SWITCH has (2) Plugs on it a BLUE and a GRAY, the (+) LIGHT BLUE BRAKE wire, marked with the RED Clip in this picture i
The BCM on this vehicle is held into place on this vehicle, under the Passenger dash, next to the Under Dash Light. It is just slid into place on a bracket. Slide it toward the Light will remove it from its holder.
This picture shows the (+) BROWN PARKING LIGHT wire, marked with the RED Clip, in the Passenger Kick Panel at a harness heading to the Rear of the Vehicle.
This is a picture of the GM-6 T-HARNESS Male End of this T-Harness, if you purchased a T-Harness for this vehicle, use this picture to make sure you recieved the correct harness. The Male End of this T-Harness plugs into the Back the Ignition Switch of th
This is a picture of the GM-6 T-HARNESS Female End of this T-Harness, if you purchased a T-Harness for this vehicle, use this picture to make sure you recieved the correct harness. The Female End of this T-Harness plugs into the Ignition Switch Harness Pl
|