Carlton, 3.0i ,, 2969 cc, 1989-, , Engine Code C30SE/J ,

Ignition data

Carlton, 3.0i
Ignition system type: El-ecu
Ignition coil make/type: Bo/0 221 122 508
Supply voltage: 11 - Volts without ballast resistor
Primary resistance: 0.65-0.79 Ohms
Secondary resistance: 6900-8500 Ohms
Distributor make/type: Bo/0 237 503 009
Contact breaker gap/air: n / a mm
Dwell angle: n / a Deg
Ignition Timing - unleaded: 8-12/570 Deg eng/rpm (without vacuum)
Ignition Timing - leaded: n / a Deg eng/rpm (without vacuum)
Timing mark location: Pulley
No 1 plug location: Pulley
Firing Order: 1-5-3-6-2-4
Spark plug make: Bosch
Spark plug type: FR7DTC
Electrode gap: 0.7-0.8 mm

Fuel System

Carlton, 3.0i
Fuel type: U Cat
Fuel pump type/pressure: Elec/2.5 bar
Engine idle speed: 570-730 rpm
Fast idle speed: n / a rpm
CO level at idle speed: 1.0 Max Vol %

Engine Data

Carlton, 3.0i
Valve clearance - inlet: Hyd
Valve clearance - exhaust: Hyd
Compression pressure: n / a bar
Oil pressure: 4.5-5.0/2000 bar/eng/rpm
Radiator pressure cap: 1.2-1-5 bar/type
Drive belt 1 - size: PV/KKB141 mm/type
Drive belt 2 - size: PV/KKB225 mm/type

Electrical System

Carlton, 3.0i
Alternator output: 90/6000 Amps/eng/rpm
Regulated output: 13.8-14.8 Volts
Battery: 12/66 V/Ah
Starter motor make/type: Ma/M78/1.4

Other data

Carlton, 3.0i
Clutch operation type: Cable
Clutch adjustment: 155/P.Travel mm
Cambelt failure: n / a
Cambelt Part Number: n / a
Tyre pressures: 2.2(31)f 2.2(31)r bar (psi)