ENGINE (DIAGNOSTICS)(H6DO) > Compulsory Valve Operation Check Mode
2. Connect the diagnosis cable to the Subaru Select Monitor.
4. Connect the test mode connector (A) located under the glove box.
5. Connect the Subaru Select Monitor to data link connector located in the lower portion of the instrument panel (on the driver’s side).
CAUTION:
Do not connect any scan tools except Subaru Select Monitor or general scan tool.
6. Turn the ignition switch to ON (engine OFF) and Subaru Select Monitor power switch to ON.
(A) |
Power switch |
7. On the «Main Menu» display screen, select the {Each System Check} and press the [YES] key.
8. On the «System Selection Menu» display screen, select the {Engine Control System} and press the [YES] key.
9. Press the [YES] key after the information of engine type has been displayed.
10. On the «Engine Diagnosis» display screen, select the {System Operation Check Mode} and press the [YES] key.
11. On the «System Operation Check Mode» display screen, select the {Actuator ON/OFF Operation} and press the [YES] key.
12. Select the desired compulsory actuator on the «Actuator ON/OFF Operation» display screen and press the [YES] key.
13. Pressing the [NO] key completes the compulsory valve operation check mode. The display will then return to the «Actuator ON/OFF Operation» screen.
• A list of the support data is shown in the following table.
Description |
Display |
Compulsory fuel pump relay operation check |
Fuel Pump |
Compulsory purge control solenoid valve operation check |
CPC Solenoid |
Compulsory radiator fan relay operation check |
Radiator Fan Relay |
Compulsory air conditioning relay operation check |
A/C Compressor Relay |
NOTE:
• The following parts will be displayed but not functional.
Display |
EGR Solenoid |
ASV Solenoid |
PCV Solenoid |
Vent Control Solenoid |
FICD Solenoid |
Pressure Switching Solenoid 1 |
Pressure Switching Solenoid 2 |
Fuel Tank Sensor Control Valve |
Wastegate solenoid |
AAI Solenoid |
Exhaust Bypass Valve Control Permit Flag |
Secondary Air Combination Valve 1 |
• For detailed operation procedure, refer to the “SUBARU SELECT MONITOR OPERATION MANUAL”.