1. Connect the inhibitor switch harness connector to the inhibitor switch.
2. Install the inhibitor switch to the transmission case.
|
(A) |
Inhibitor switch |
3. Move the range select lever to the neutral position.
4. Tighten the three inhibitor switch securing bolts using the ST.
| ST 499267300 | STOPPER PIN |
Tightening torque:
3.4 N·m (0.35 kgf-m, 2.5 ft-lb)
|
(A) |
Inhibitor switch |
|
(B) |
Range select lever |
5. Install the select cable to the range select lever.
6. Install the plate assembly to the transmission.
Tightening torque:
T: 25 N·m (2.5 kgf-m, 18.4 ft-lb)
|
(A) |
Select cable |
|
(B) |
Plate ASSY |
7. Install the washer and snap pin to the range select lever.
|
(A) |
Range select lever |
|
(B) |
Snap ring |
|
(C) |
Select cable |
|
(D) |
Washer |
8. Install the front and center exhaust pipe.
9. Lower the vehicle.
10. Install the inhibitor switch connector to the stay.
11. Connect the inhibitor switch connector.
|
(A) |
Inhibitor switch connector |
12. Install the air intake chamber.
13. Inspect the inhibitor switch.