PRINT
SATURN L-SERIES
MODEL YEAR(S
L-SERIES 2000-2002
KEY T-HARNESS IMMOBILIZER
N/A N/A GM's PASSLOCK 2 ANTI-THEFT System, Requires 791 Bypass Module
PART COLOR LOCATION DIAGRAM
12 VOLT CONSTANT RED (+) IGNITION SWITCH HARNESS
STARTER YELLOW(+) IGNITION SWITCH HARNESS
STARTER 2 N/A
IGNITION 1 PINK(+) IGNITION SWITCH HARNESS
IGNITION 2 GREEN (+) IGNITION SWITCH HARNESS
IGNITION 3 N/A
ACCESSORY/HEATER BLOWER 1 ORANGE (+) IGNITION SWITCH HARNESS
ACCESSORY/HEATER BLOWER 2 N/A
KEYSENSE LIGHT GREEN (-) See NOTE *1 IGNITION SWITCH HARNESS
PARKING LIGHTS ( - ) N/A
PARKING LIGHTS ( + ) BROWN (+) @ STEERING COLUMN HARNESS
POWER LOCK ORANGE/BLACK (TYPE A) IN DRIVERS KICK PANEL
POWER UNLOCK RED/BLACK (TYPE A) IN DRIVERS KICK PANEL
LOCK MOTOR WIRE GRAY (+) IN DRIVERS KICK PANEL
DOOR TRIGGER See NOTE *2 @ BCM, See NOTE *4 14301_L-SERIES_(-) NEGATIVE DOOR PIN ISOLATION CIRCUIT.pdf
DOMELIGHT SUPERVISION GRAY/BLACK (-) @ BCM, See NOTE *4
TRUNK RELEASE BLACK (+), Requires Part #775 Relay @ TRUNK RELEASE SWITCH
SLIDING POWER DOOR N/A
HORN BLACK (-) @ STEERING COLUMN HARNESS
TACH See NOTE *3
WAIT TO START LIGHT N/A
BRAKE LIGHT BLUE (+) @ SWITCH ABOVE BRAKE PEDAL
FACTORY ALARM DISARM N/A
ANTI-THEFT YELLOW (+) and BLACK (-) and WHITE (Not Used) GM's PASSLOCK 2 System, wires are under the Steering Column cover, at the Bottom of the Ignition Switch Tumbler in a BLACK or DARK GRAY Plug
NOTES
NOTE *1 THE LIGHT GREEN (-) KEY SENSE WIRE AT THE STEERING COLUMN, MUST SEE A (-)NEGATIVE DURING REMOTE START TO KEEP THE SERVICE ENGINE LIGHT FROM COMING ON.

SPLICE THE BANDED END OF A 1 AMP RECTIFIER DIODE(1N4004, FROM RADIO SHACK) TO THE NEGATIVE STATUS OUTPUT WIRE(SAME WIRE THAT RUNS TO YOUR BYPASS MODULE) FROM REMOTE STARTER, TAP UNBANDED END OF DIODE INTO THE KEYSENSE WIRE.





NOTE *2 THE DRIVERS DOOR IS GRAY/BLACK (-).THE OTHER DOORS ARE BLACK/WHITE (-). BOTH WIRES ARE IN THE GRAY 24-PIN PLUG AT THE BCM. WHEN CONNECTING TO AN ALARM SYSTEM, USE BOTH DOOR TRIGGER WIRES AND DIODE ISOLATE, TO CONNECT, SEE DIAGRAM





NOTE *3 ON THE 4 CYLINDER MODELS USE PURPLE/WHITE AT THE IGNITION MODULE ON THE DRIVERS SIDE OF THE MOTOR. ON THE 6 CYLINDER MODELS AT THE IGNITION COILS ON TOP OF THE CYLINDER HEAD ON THE DRIVERS SIDE OF THE MOTOR, USE ANY 1 OF THE 3 WIRES THAT IS NOT PINK OR BLACK.





NOTE *4 THE BCM (Body Control Module) IS LOCATED ABOVE THE GLOVE BOX.
LINK 1 LINK TEXT 1 LINK 2 LINK TEXT 2