PRINT

MITSUBISHI ECLIPSE

MODEL	YEAR(S
ECLIPSE	2003-2005

KEY	T-HARNESS	IMMOBILIZER
N/A	N/A	MITSUBISHI TRANSPONDER ANTI-THEFT SYSTEM, Requires 791 Bypass Module and extra Ignition Key

PART	COLOR	LOCATION	DIAGRAM
12 VOLT CONSTANT	WHITE/RED (+)	IGNITION SWITCH HARNESS
STARTER	BLACK/RED (+)	IGNITION SWITCH HARNESS
STARTER 2	N/A
IGNITION 1	GREEN (+)	IGNITION SWITCH HARNESS
IGNITION 2	N/A
IGNITION 3	N/A
ACCESSORY/HEATER BLOWER 1	BLUE/RED (+)	IGNITION SWITCH HARNESS
ACCESSORY/HEATER BLOWER 2	BLUE/BLACK (+)	IGNITION SWITCH HARNESS
KEYSENSE	N/A
PARKING LIGHTS ( - )	N/A
PARKING LIGHTS ( + )	GREEN/WHITE (+)	IN DRIVERS KICK PANEL, HARNESS to REAR of VEHICLE
POWER LOCK	PURPLE (TYPE B)	@ LARGER BLACK Plug, in Harness from DRIVERS DOOR or IN PIN 33 @ ETACS ECU, See NOTE *1
POWER UNLOCK	LIGHT GREEN/RED (TYPE B)	@ LARGER BLACK Plug, in Harness from DRIVERS DOOR or IN PIN 34 @ ETACS ECU, See NOTE *1
LOCK MOTOR WIRE	LIGHT GREEN (+)	@ 28-PIN PLUG, PIN 19, BELOW FUSEBOX
DOOR TRIGGER	See NOTE *2	@ ETACS ECU, See NOTE *1	14301_ECLIPSE_(-) NEGATIVE DOOR PIN ISOLATION CIRCUIT.pdf
DOMELIGHT SUPERVISION	LIGHT GREEN (-) (Same wires as Drivers Door Trigger), Requires Part #775 Relay	IN DRIVERS KICK PANEL, HARNESS to REAR of VEHICLE
TRUNK RELEASE	GREEN/WHITE (5wire) See NOTE *4	IN PIN 32 @ ETACS ECU, See NOTE *1	14301_ECLIPSE_5-WIRE TRUNK RELEASE DIAGRAM.pdf
SLIDING POWER DOOR	N/A
HORN	LIGHT GREEN/BLACK ( - )	@ STEERING COLUMN HARNESS
TACH	WHITE	@ ENGINE SPEED DETECT CONNECTOR See NOTE *3
WAIT TO START LIGHT	N/A
BRAKE	GREEN/ORANGE ( + )	@ SWITCH ABOVE BRAKE PEDAL
FACTORY ALARM DISARM	ORANGE ( - )	IN PIN 25 @ ETACS ECU, See NOTE *1
ANTI-THEFT	TRANSPONDER ANTI-THEFT SYSTEM, REQUIRES 791 BYPASS MODULE AND EXTRA IGNITION KEY	TRANSPONDER @ IGNITION SWITCH TUMBLER

NOTES

NOTE *1 ETACS (Electronic Timing/Alarm Control System) ECU (Electronic Control Unit) IS ATTACHED TO BACK OF FUSEBOX. NOTE *2 THE DRIVERS DOOR TRIGGER IS LIGHT GREEN(-),IN DRIVERS KICK PANEL, HARNESS to REAR of VEHICLE OR PIN 6 IN A 15 PIN PLUG ABOVE THE FUSES.THE PASSENGER DOOR IS LIGHT GREEN/BLACK(-), IN PASSENGERS KICK PANEL, OR IN PIN 65 AT THE ETACS ECU. WHEN CONNECTING TO AN ALARM SYSTEM USE BOTH DOOR TRIGGER WIRES AND DIODE ISOLATE, TO CONNECT, SEE DIAGRAM NOTE *3 THE ENGINE SPEED DETECTION CONNECTOR IS A SINGLE PIN CONNECTOR IN THE FUSE/RELAY BOX UNDER THE HOOD. NOTE *4 THE TRUNK RELEASE ON THIS VEHICLE IS A 5-WIRE SYSTEM THAT WILL REQUIRE AN EXTRA RELAY PART #775, TO CONNECT, See DIAGRAM

LINK 1	LINK TEXT 1	LINK 2	LINK TEXT 2

EXTRA INFORMATION

With the Metal Knee Bolster removed, you can now get to the Brake Switch and Brake Switch wire above the Brake and all other Under Dash wiring. Then remove the fifth Philip's Head screw just above the Ignition Switch Tumbler on the Steering column. To gain access to the Under Dash wiring of this vehicle, you will first need to remove this Under Dash Panel just below the Steering Column. This panel in held in place by (4) Philip Head screws at each corner of the panel. Before removing the (4) screws that holds this Under Dash panel in place, remove the (2) Philip Head screws that holds the Hood Release to the Under dash panel. By doing so will let you remove this panel and set it aside. With the Under Dash panel removed, next remove the Metal Knee Bolster, it is held in place by (2) 10mm Bolts, with these bolts removed the Metal Knee Bolster will pull off. To access the IGNITION SWITCH HARNESS Plug and the TRANSPONDER ANTI-THEFT System on this vehicle, you will need to remove the Lower Steering Column cover. To do this, you will need to remove (5) Philip Head screws. First remove these (4) screws at the bot With all (5) screws removed, this Lower Column cover will unsnap and pull off, leave the Upper Column cover in place. With the Lower Column Cover removed, you can now get to the Transponder Antenna Ring around the Ignition Switch Tumbler and the Ignition Switch Harness Plug on the Left side of the Steering Column. The IGNITION SWITCH HARNESS Plug, is attached to the Ignition Switch on the Left side of the Column. The Ignition Harness Plug is the Lower WHITE Plug with the LIGHT BLUE Plastic cover in this picture. For this picture we unplugged the IGNITION SWITCH HARNESS, from the Ignition Switch, to get a better picture of the IGNITION wires in this plug. The (-) LIGHT GREEN/BLACK HORN wire, marked with the RED Clip, is located at the BLACK Plug at the top of the Steering Column, just behind the Steering Wheel, next to the Air bag wires, note the Air bag wires are the YELLOW and the YELLOW/BLACK wires in t The (+) GREEN/ORANGE BRAKE wire, marked with the BLACK Clip, is located at the Brake Switch that is attached to the top of the Brake Pedal on this vehicle. The (+) GREEN/WHITE PARKING LIGHT wire, marked with the RED Clip, is located in the Main Harness in the Drivers Kick Panel, heading to the REAR of the Vehicle. The (-) LIGHT GREEN DOME LIGHT SUPERVISION wire (that is also the DRIVERS DOOR TRIGGER wire), marked with the RED Clip, is located in the Main Harness in the Drivers Kick Panel, heading to the REAR of the Vehicle. This is a picture of the DRIVERS DOOR HARNESS Plug that exits the Drivers Door and is located in the Drivers Kick Panel. This plug contains both the Lock and the Unlock wires for this vehicle. The (TYPE B) PURPLE LOCK wire, marked with the BLACK Clip, is located in the LARGE BLACK DRIVERS DOOR HARNESS Plug in the Drivers Kick Panel. The (TYPE B) LIGHT GREEN/RED UNLOCK wire, marked with the BLACK Clip, is located in the LARGE BLACK DRIVERS DOOR HARNESS Plug in the Drivers Kick Panel.