Valves, Springs, and Valve Seals Installation
Special Tools Required
Stem seal driver ( 07PAD-0010000)
Valve spring compressor attachment ( 07757-PJ10100)
Valve spring compressor ( 07757-0010000)
| 1. | Coat the valve stems with engine oil. Install the valves in the valve guides.
|
| 2. | Check that the valves move up and down smoothly.
|
| 3. | Install the spring seats on the cylinder head.
|
| 4. | Install the new valve seals (A) using the valve guide seal installer (B).
NOTE: The exhaust valve seal (C) has a black spring (D), and the intake valve seal (E) has a white spring (F). They are not interchangeable.
 FDECAB
07PAD-0010000
NOTE: Use 5.5 mm side. |
| 5. | Install the valve springs. Place the end of the valve spring with closely wound coils toward the cylinder head.
|
| 6. | Install the valve retainer.
|
| 7. | Install the valve spring compressor. Compress the spring, and install the valve keepers.
 07757-PJ1010007757-0010000 |
| 8. | Lightly tap the end of each valve stem two or three times with a plastic mallet (A) to ensure proper seating of the valve and valve keepers. Tap the valve stem only along its axis so you do not bend the stem.
 A |
