Radio Remote Switch Test

Radio Remote Switch Test

1.	Remove the driver's airbag assembly.

2.	Remove the 4P connector (A) from the radio remote switch (B). AB

3.	Remove the two mounting screws and the switch.

4.	Measure resistance between the No. 3 and No. 4 terminals in each switch position according to the table. Position  Resistance  OFF  About 10 kW  MODE  About 6 kW  CH (+)  About 2 kW  CH (-)  About 840 W    About 370 W    About 100 W

5.	If the resistance is not as specified, replace the remote switch.