Front Air Spoiler Replacement - Sport Type

Type-S

NOTE:

Take care not to scratch the front bumper.
Put on gloves to protect your hands.

Remove the screws (A) from the rear edge of the front air spoiler (B).

Adhesive tape
D: 3M 7120, or equivalentThickness=2.0 mm (0.08 in.),
Length=200 mm (7.87 in.)G: 3M GT7108, or equivalentThickness=0.8 mm (0.03 in.),
Length=50 mm (2.0 in.)ABCDEFGAAACCCCCCCDDEGBDF6 x 1.0 mm
9.8 N·m
(1.0 kgf·m, 7.2 lbf·ft): Screw, 4A: Bolt, 8CFastener Locations

2.	Remove the bolt (C) from under the front air spoiler.

3.	Pull the front air spoiler back along the edge of it near the double-sided adhesive tapes (D) and spacers (E) to release them from the front bumper (F), then remove the spoiler. If the spoiler is to be reinstalled, do not damage the spacers during removal.

Install the spoiler in the reverse order of removal, and note these items:

Before installing the spoiler, fold the edge of the adhesive backing from the double-sided adhesive tape. After installing the spoiler, carefully pull the adhesive backing away, and push the spoiler into place securely.
If the spoiler is to be reinstalled, replace the double-sided adhesive tapes as new ones:

-1	Remove the spacers from the spoiler. Take care not to damage them during removal.
-2	Scrape off the remaining double-sided adhesive tape from the spoiler, and bumper.
-3	Clean the spoiler, spacers, and bumper surfaces with a sponge dampened in alcohol where adhesive tape will be applied.
-4	Apply primer (3M N-200, or equivalent) to the spacer where adhesive tape will be applied.
-5	Glue the double-sided adhesive tapes (D) (3M GT7120, or equivalent) to the spoiler, and the double-sided adhesive tapes (G) (3M GT7108, or equivalent) on each side of the spacers.
-6	Glue the spacers on the back surface of the front fog light openings.