Instrument Panel Removal/Installation

Instrument Panel Removal/Installation

NOTE:

• When prying with a flat-tip screwdriver, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage.
  
• Take care not to scratch the dashboard and related parts.
  
• LHD is shown; RHD is symmetrical.
  

1.	Tilt the steering column down.

2.

Remove the instrument panel (A). -1  Remove the screws (B). -2  Gently pull out along the bottom to release the clips (C) and hooks (D). -3  Gently pull out the upper portion of the panel. -4  With auto A/C: Disconnect the in-car temperature sensor connector (E) and the air hose (F). Fastener Locations: Screw, 2B: Clip, 2CDFEADBBCC

3.	Install the panel in the reverse order of removal. If equipped, make sure the in-car temperature sensor connector is plugged in properly, and the air hose is connected securely.