DTC Troubleshooting: 32-3x

DTC 32-3x (32-30 to 32-39, 32-3A to 32-3F):

Short to Another Wire or Decreased Resistance in Right Side Airbag Inflator

Special Tools Required
SRS inflator simulator ( 07SAZ-TB4011A)

SRS simulator lead E ( 07XAZ-S1A0200)

SRS short canceller ( 070AZ-SAA0100)

1.	Erase the DTC memory.

Turn the ignition switch ON (II), and check that the SRS indicator comes on for about 6 seconds and then goes off.

Does the SRS indicator stay on and is DTC 32-3x indicated?

YES - Go to 3.

NO - Intermittent failure, system is OK at this time. Go to Troubleshooting Intermittent Failures. If another DTC is indicated, go to the DTC troubleshooting index for troubleshooting details.

3.	Turn the ignition switch OFF. Disconnect the battery negative cable, and wait for 3 minutes.

4.	Disconnect the floor wire harness 2P connector (A) from the right side airbag. A07SAZ-TB4011A07XAZ-S1A0200

5.	Connect the SRS inflator simulator (2 W connector) and the simulator lead to the floor wire harness.

6.	Reconnect the battery negative cable.

7.	Erase the DTC memory.

8.	Read the DTC. Is DTC 32-3x indicated? YES - Go to 9. NO - Short to another wire in the right side airbag inflator; replace the right side airbag.

9.	Turn the ignition switch OFF. Disconnect the battery negative cable, and wait for 3 minutes.

10.	Disconnect both seat belt tensioner 4P connectors (A). A

11.	Disconnect SRS unit connector B (28P) from the SRS unit. B

12.	Disconnect the SRS inflator simulator from the SRS simulator lead E.

13.	Connect the SRS short canceller (070AZ-SAA0100) to No. 23 and No. 24 terminals of SRS unit connector B (28P).

14.	Check resistance between the terminals of the SRS simulator lead E. There should be an open circuit, or at least 1 MW. 07XAZ-S1A0200FLOOR WIRE HARNESS 2P CONNECTOR Is the resistance as specified? YES - Replace the SRS unit .n NO - Replace the floor wire harness.n