DTC Troubleshooting: 44-1x
DTC Troubleshooting: 44-1x
| DTC 44-1x (44-10 to 44-19, 44-1A to 44-1F): | No Signal from the Right Side Impact Sensor (1st) |
Special Tools Required
SRS inflator simulator ( 07SAZ-TB4011A)
| 1. | Erase the DTC memory. |
| 2. | Turn the ignition switch ON (II), and check that the SRS indicator comes on for about 6 seconds and then goes off. Does the SRS indicator stay on and is DTC 44-1x indicated? YES - Go to 3. NO - Intermittent failure, system is OK at this time. Go to Troubleshooting Intermittent Failures. If another DTC is indicated, go to the DTC troubleshooting index for troubleshooting details. |
| 3. | Turn the ignition switch OFF. Disconnect the battery negative cable, and wait for 3 minutes. |
| 4. | Check the connection between the floor wire harness 2P connector and the right side impact sensor (1st). Is the connection OK? YES - Go to 5. NO - Replace the right side impact sensor (1st) and/or the floor wire harness, as needed.n |
| 5. | Disconnect both seat belt tensioner 4P connectors (A). A |
| 6. | Disconnect the floor wire harness 2P connector (A) from the right side impact sensor (1st). A07SAZ-TB4011A07YAZ-S3A0100 |
| 7. | Connect the SRS inflator simulator (jumper connector) and the simulator lead to the floor wire harness. |
| 8. | Disconnect SRS unit connector B (28P) from the SRS unit. B |
| 9. | Check resistance between the No. 25 and No. 26 terminals of SRS unit connector B (28P). There should be 1.0 W or less. SRS UNIT CONNECTOR B (28P)Wire side of female terminalsBRN/YELLT GRN/REDIs the resistance as specified? YES - Faulty right side impact sensor (1st) or SRS unit; replace the sensor. If the problem is still present, replace the SRS unit.n NO - Open in the floor wire harness; replace the floor wire harness.n |