DTC Troubleshooting: 46-1x
DTC Troubleshooting: 46-1x
| DTC 46-1x (46-10 to 46-19, 46-1A to 46-1F): | No Signal from the Right Side Impact Sensor (2nd) |
Special Tools Required
SRS inflator simulator ( 07SAZ-TB4011A)
| 1. | Erase the DTC memory. |
| 2. | Turn the ignition switch ON (II), and check that the SRS indicator comes on for about 6 seconds and then goes off. Does the SRS indicator stay on and is DTC 46-1x indicated? YES - Go to 3. NO - Intermittent failure, system is OK at this time. Go to Troubleshooting Intermittent Failures. If another DTC is indicated, go to the DTC troubleshooting index for troubleshooting details. |
| 3. | Turn the ignition switch OFF. Disconnect the battery negative cable, and wait for 3 minutes. |
| 4. | Check the connection between the side curtain airbag subharness 2P connector and the right side impact sensor (2nd). Is the connection OK? YES - Go to 5. NO - Replace the right side impact sensor (2nd) and/or the side curtain airbag subharness, as needed .n |
| 5. | Disconnect the right side curtain airbag 2P connector (A) and side curtain airbag subharness. A |
| 6. | Disconnect the side curtain airbag subharness 2P connector (A) from the right side impact sensor (2nd). A07YAZ-S3A010007SAZ-TB4011A |
| 7. | Connect the SRS inflator simulator (jumper connector) and the simulator lead to the side curtain airbag subharness. |
| 8. | Disconnect SRS unit connector C (16P) from the SRS unit. C |
| 9. | Check resistance between the No. 15 and No. 16 terminals of the SRS unit connector C. There should be 1.0 W or less. SRS UNIT CONNECTOR C (16P)Wire side of female terminalsYELYEL/BLKIs the resistance as specified? YES - Faulty right side impact sensor (2nd) or SRS unit; replace the right side impact sensor (2nd). If the problem is still present, replace the SRS unit.n NO - Open in the side curtain airbag subharness; replace the side curtain airbag subharness.n |