DTC Troubleshooting: 91-1x

DTC 91-1x (91-10 to 91-19, 91-1A to 91-1F):

Internal Failure of the SRS Unit

NOTE: Before troubleshooting any of these DTCs, check the battery/system voltage. If the voltage is low, repair the charging system before troubleshooting the SRS system. If the battery/system voltage is now OK, ask the customer if the battery ever went dead.

1.	Erase the DTC memory.

Turn the ignition switch ON (II), and check that the SRS indicator comes on for about 6 seconds and then goes off.

Does the SRS indicator stay on and is DTC 91-1x indicated?

YES - Replace the SRS unit.n

NO - Intermittent failure, system is OK at this time. Go to Troubleshooting Intermittent Failures. If another DTC is indicated, go to the DTC troubleshooting index for troubleshooting details.