A/T Clutch Pressure Control Solenoid Valve A Replacement (A/T)

A/T Clutch Pressure Control Solenoid Valve A Replacement

1.	Remove the intake air duct.

2.	Disconnect the A/T clutch pressure control solenoid valve A connector.

3.	Remove the bolts securing the ATF cooler inlet line brackets (B) from the transmission hanger (C). 6 x 1.0 mm 12 N·m (1.2 kgf·m, 8.7 lbf·ft)ADFGEBC6 x 1.0 mm 12 N·m (1.2 kgf·m, 8.7 lbf·ft)

4.	Remove the mounting bolts and the  A/T clutch pressure control solenoid valve A.

5.	Remove the ATF pipe (D), ATF joint pipes (E), O-rings (F), and gasket (G).

6.	Clean the mounting surface and fluid passages of the A/T clutch pressure control solenoid valve A and transmission housing.

7.	Install the new gasket on the transmission housing, and install the ATF pipe and ATF joint pipes.

8.	Install the new O-rings over the ATF joint pipes.

9.	Install the new A/T clutch pressure control solenoid valve A.

10.	Secure the ATF cooler inlet line brackets with the bolts on the transmission hanger.

11.	Check the A/T clutch pressure control solenoid valve A connector for rust, dirt, or oil, then connect the connector securely.

12.	Install the intake air duct.