Transmission Range Switch Test (A/T)

Transmission Range Switch Test

Remove the transmission range switch harness connector (A) from the connector bracket (B), then disconnect the connector.

ABTerminal side of
male terminals

**Connector Terminal Specification**
Terminal	Signal	Terminal	Signal
1	ATP NP (ST)	6	ATP FWD
2	ATP RVS	7	[D]
3	Ground (E)	8	[N]
4	———	9	[R]
5	[D3]	10	[P]

2.	Check for continuity between terminals at the harness connector. There should be continuity between the terminals in the following table for each switch position. Connector Terminal25134687910[P][R][N][D][D3]../../PNG/CO000006.BMP

If there is no continuity between any terminals, remove the transmission range switch cover, and disconnect the connector at the switch.

**Connector Terminal Specification**
Terminal	Signal	Terminal	Signal
1	ATP RVS	6	[P]
2	[N]	7	[R]
3	[D3]	8	[D]
4	ATP NP (ST)	9	———
5	ATP FWD	10	Ground (E)

4.	Check for continuity between terminals at the switch connector. There should be continuity between the terminals in the following table for each switch position. Connector Terminal25134687910[P][R][N][D][D3]../../PNG/CO000007.BMP

5.	If the transmission range switch continuity check is OK, replace the faulty transmission range switch harness.

If there is no continuity between any terminals, remove the transmission range switch, and check the end of the selector control shaft (A).

Standard:

Control Shaft Width (B):
6.1-6.2 mm (0.240-0.244 in.)

Control Shaft End Gap (C):
1.8-2.0 mm (0.07-0.08 in.)

ACB

7.	The measurement of the control shaft end is within the standard, replace the transmission range switch. If the measurement is out of the standard, repair the control shaft end, and recheck the transmission range switch continuity.