Mainshaft Disassembly, Inspection, and Reassembly (A/T)
Mainshaft Disassembly, Inspection, and Reassembly
| 1. | Inspect the thrust needle bearing and the needle bearing for galling and rough movement. LOCKNUT (FLANGE NUT)24 x 1.25 mm 226 N·m (23.0 kgf·m, 166 lbf·ft)®0® 167 N·m (17.0 kgf·m, 123 lbf·ft) Repalce.CONICAL SPRING WASHER Replace.IDLER GEARTRANSMISSION HOUSING BEARINGTHRUST NEEDLE BEARING4TH GEARNEEDLE BEARINGTHRUST NEEDLE BEARING4TH GEAR COLLAR4TH/5TH CLUTCHO-RING Replace.THRUST WASHER, 41 x 68 mm Selective partNEEDLE BEARINGTHRUST NEEDLE BEARING5TH GEARTHRUST NEEDLE BEARINGSET RINGS, 29 mmNEEDLE BEARINGSET RING |
| 2. | Inspect the splines for excessive wear and damage. |
| 3. | Check shaft bearing surface for scoring and excessive wear. |
| 4. | Before installing the O-rings, wrap the shaft splines with tape to prevent O-ring damage. |
| 5. | Lubricate all parts with ATF during assembly. |
| 6. | Install the conical spring washer, 41 x 68 mm thrust washer in the direction shown. |
| 7. | Replace the locknut and conical spring washer with new ones when assembling the transmission. |
| 8. | Check the clearance of the 5th gear. |